[PATCH 2/2] rainier: Add LEDs that are controlled by ASPEED

[vishwanatha subbanna]

These are the LEDs that have direct GPIO connection from ASPEED

Signed-off-by: Vishwanatha Subbanna <vishwa at linux.vnet.ibm.com>
---
arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts | 24 ++++++++++++++++++++++--
1 file changed, 22 insertions(+), 2 deletions(-)

diff --git a/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts b/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts
index ecbce50..dc68c49 100644
--- a/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts
+++ b/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts
@@ -72,6 +72,26 @@
	leds {
		compatible = "gpio-leds";

+		/* BMC Card fault LED at the back */
+		bmc-ingraham0 {
+			gpios = <&gpio0 ASPEED_GPIO(H, 1) GPIO_ACTIVE_LOW>;
+		};
+
+		/* Enclosure ID LED at the back */
+		rear-enc-id0 {
+			gpios = <&gpio0 ASPEED_GPIO(H, 2) GPIO_ACTIVE_LOW>;
+		};
+
+		/* Enclosure fault LED at the back */
+		rear-enc-fault0 {
+			gpios = <&gpio0 ASPEED_GPIO(H, 3) GPIO_ACTIVE_LOW>;
+		};
+
+		/* PCIE slot power LED */
+		pcieslot-power {
+			gpios = <&gpio0 ASPEED_GPIO(P, 4) GPIO_ACTIVE_LOW>;
+		};
+
		/* System ID LED that is at front on Op Panel */
		front-sys-id0 {
			retain-state-shutdown;
@@ -112,7 +132,7 @@
	/*E0-E7*/	"","","","","","","","",
	/*F0-F7*/	"","","","","","","","",
	/*G0-G7*/	"","","","","","","","",
-	/*H0-H7*/	"","","","","","","","",
+	/*H0-H7*/	"","bmc-ingraham0","rear-enc-id0","rear-enc-fault0","","","","",
	/*I0-I7*/	"","","","","","","","",
	/*J0-J7*/	"","","","","","","","",
	/*K0-K7*/	"","","","","","","","",
@@ -120,7 +140,7 @@
	/*M0-M7*/	"","","","","","","","",
	/*N0-N7*/	"","","","","","","","",
	/*O0-O7*/	"","","","","","","","",
-	/*P0-P7*/	"","","","","","","","",
+	/*P0-P7*/	"","","","","pcieslot-power","","","",
	/*Q0-Q7*/	"cfam-reset","","","","","","","",
	/*R0-R7*/	"","","","","","","","",
	/*S0-S7*/	"presence-ps0","presence-ps1","presence-ps2","presence-ps3",
-- 
1.8.3.1