[PATCH 2/2] rainier: Add LEDs that are controlled by ASPEED

[Vishwanatha Subbanna]

These are the LEDs that have direct GPIO connection from ASPEED

Signed-off-by: Vishwanatha Subbanna <vishwa at linux.vnet.ibm.com>
---
 arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts | 17 ++++++++++++++++-
 1 file changed, 16 insertions(+), 1 deletion(-)

diff --git a/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts b/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts
index ecbce50..e6a5875 100644
--- a/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts
+++ b/arch/arm/boot/dts/aspeed-bmc-ibm-rainier.dts
@@ -72,6 +72,21 @@
 	leds {
 		compatible = "gpio-leds";
 
+		/* BMC Card fault LED at the back */
+		bmc-ingraham0 {
+			gpios = <&gpio0 ASPEED_GPIO(H, 1) GPIO_ACTIVE_LOW>;
+		};
+
+		/* Enclosure ID LED at the back */
+		rear-enc-id0 {
+			gpios = <&gpio0 ASPEED_GPIO(H, 2) GPIO_ACTIVE_LOW>;
+		};
+
+		/* Enclosure fault LED at the back */
+		rear-enc-fault0 {
+			gpios = <&gpio0 ASPEED_GPIO(H, 3) GPIO_ACTIVE_LOW>;
+		};
+
 		/* System ID LED that is at front on Op Panel */
 		front-sys-id0 {
 			retain-state-shutdown;
@@ -112,7 +127,7 @@
 	/*E0-E7*/	"","","","","","","","",
 	/*F0-F7*/	"","","","","","","","",
 	/*G0-G7*/	"","","","","","","","",
-	/*H0-H7*/	"","","","","","","","",
+	/*H0-H7*/	"","bmc-ingraham0","rear-enc-id0","rear-enc-fault0","","","","",
 	/*I0-I7*/	"","","","","","","","",
 	/*J0-J7*/	"","","","","","","","",
 	/*K0-K7*/	"","","","","","","","",
-- 
1.8.3.1