NCSI eth0 (ftgmac100): transmit queue 0 timed out error

Евгений 9165394577 at mail.ru
Sat Nov 23 19:20:50 AEDT 2019


Hello Andrew,

It turned out that the i210 firmware was not loaded by the manufacturer. 
Maybe this is normal, but how then did they test the board?

Anyway, thanks for the help.

Sincerely,

Evgeniy

22.11.2019 3:50, Andrew Jeffery пишет:
> Hi Evgeniy,
>
> Please make sure to Reply-All or Cc openbmc at lists.ozlabs.org on your
> OpenBMC queries, that way others can learn from the discussion as well.
>
> On Fri, 15 Nov 2019, at 18:53, Евгений wrote:
>>   
>> Hello Andrew,
>>
>> It seems that I sent you not quite what you asked. Therefore, I send in
>> the attachment the final
>>
>> my_neptune_from_dtb.dts
>>
>> file made from the dtb file with the dtc utility, as well as the dtb itself.
>>
>> Maybe you will find pin conflicts in it. Thanks for the help anyway.
> Had a quick look but it would be better if you could send me the actual
> source rather than the DTS decompiled from a DTB. Do you have access
> to it?
>
> Regardless, can you please build and boot a kernel with
> CONFIG_DEBUG_PINCTRL=y and send me the full dmesg output of the
> booted system that shows your symptom?
>
> Cheers,
>
> Andrew


More information about the openbmc mailing list