does Gianfar Ethernet Controller Version 1.1 support MARVELL 88E1111?

[Liu Dave-r63238]

> 
> The PHY ID I read is MARVELL 88E1101(1410cc2)
> 
The MDIO bus is working well, the 88E1101's ID is 1410c6x,
the 88E1111 is 1410ccx.

> Today I took the MPC 8540 off the board, and checked the two
> GMII phy chips 
> alone. I manually pulled up the phys's RST pins when the cable was in 
> position. But the link LED still can't light up. So it turned 
> out not the 
> driver's problem. 
> 
Do you have a low reset pulse to PHY before pull up the RSTn?

> The hardware configuration of 88E1111 is GMII to copper, Auto-Neg,
> advertise all capabilities, prefer Master.
> 
> The PHY's power is correct and clean. And for interface
> between TESC and 
> PHY I think even TESC power is set for 3.3V environment it 
> still can work 
> with the 88e1111 whose VDD is 2.5V. Because the datasheet of 
> 88e1111 says 
> that input pins are 3.3V tolerant. Am I right?
> 
You are right.

-Dave