how to make a PCI net card work on ICECUBE ?

[debora liu]

Hello, 夏雨

In message <2005-09-29 11:56:32 xiay at nari-relays.com> you wrote:

>Thanks for your help.
>
>I found out that the ICECUBE board could tftpboot via the PCI netcard if wire net to the card, but the board could not mount NFS via the card.
tftpboot could down kernel use eth0 or eth1 with uboot
>
>So i set the environment ethact to i82559#0 and saveenv , but the board still could not mount NFS via the card.During the booting-up ,there was nothing about eth1 shown .
which is eth0 in kernel?
>
>And i wired net to the FEC ethernet port,reset the board,found that the environment ethact was now FEC ETHERNET,so i set it again to i82559#0 and saveenv,booted up the kernel, there was nothing about eth1 shown , i tried ifconfig eth1 * up ,information were below: 
>
>bash-2.05b# ifconfig eth1 198.87.102.218 up
>SIOCSIFADDR: No such device
>eth1: unknown interface: No such device
>eth1: unknown interface: No such device 
Do you regiest i82559 driver?
				 
　　　　　　　　Debora Liu
　　　　　　　　deboralh at sinovee.com
　　　　　　　　　　2005-09-29