PCMCIA on TQM8xxL

[Wolfgang Grandegger]

On 01/23/2003 03:02 PM Steven Scholz wrote:
>
> Leonardo Pereira Santos wrote:
>>
>>
>> 1) Define _IO_BASE and _IO_BASE_SIZE in arch/ppc/platforms/tqm8xxl.h
>> 2) just copy and paste the line of code for the RPX to TQM8xxL section in
>> arch/ppc/kernel/m8xx_setup.c m8xx_map_io(), as you pointed. If there's no
>> #ifdef CONFIG_TQM8XXL (or something like that), just create one near the ones
>> already defined for FADS, RPX, MBX. For example, for my FADS board, its
>> section looks like this:
>>
>> #ifdef CONFIG_FADS
>>         io_block_mapping(BCSR_ADDR, BCSR_ADDR, BCSR_SIZE, _PAGE_IO);
>>         io_block_mapping(_IO_BASE,_IO_BASE,_IO_BASE_SIZE, _PAGE_IO);
>> #endif
> ...
>
> I know. That's what I did.
>
> The problem is:
>
> DENX claims that PCMCIA is working on TQM8xxL using ELDK 2.0 and their linux CVS
> tree.
> But I can't see how! Since there's no remapping of _IO_BASE for TQM8xxL.
>
> Maybe I just have to wait until Wolfgang Denk is online again!

It's also not working on my TQM8xxL starter kit and I remember vaguely
that Wolfgang mentioned that the PCMCIA support ist not yet fully
implemented and tested (compared with our 2.4.4 kernel). But even with
io_block_mapping(_IO_BASE, ...) I still get an Oops in do_probe():

ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx
PCMCIA slot B: phys mem e0000000...ec000000 (size 0c000000)
Card ID: HITACHI FLASH 5.0
 Fixed Disk Card
 IDE interface
 [silicon] [unique] [single] [sleep] [standby] [idle] [low power]
Oops: kernel access of bad area, sig: 11
NIP: C00B69FC XER: 8000AA7F LR: C00B69D8 SP: C01F9EF0 REGS: c01f9e40
TRAP: 0300

Thanks,

Wolfgang.


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/