NFS problem

[t.shantha.laxmi at exgate.tek.com]

This is the problem with the ethernet driver. Make sure you have enabled the
Ethernet Transciever. You need to add code in enet.c to enable the
transciever and set the TENA bit.

Hope this helps,

- Shantha

-> -----Original Message-----
-> From: Navin Boppuri [mailto:nboppuri at trinetcommunication.com]
-> Sent: Friday, May 26, 2000 6:58 PM
-> To: linuxppc-embedded at lists.linuxppc.org
-> Subject: NFS problem
->
->
->
-> Hello,
->
-> I am trying to boot my custom board with the linux 2.2.13
-> kernel. It boots
-> OK but when it tries to do the NFS mount, it fails.......
-> This is how it
-> looks. I dont understand what's going on. I testing the NFS
-> server with some
-> other board and same ip's and it works fine. Any ideas????
->
-> lcd_lcvcr: 78000
-> loop: registered device at major 7
-> eth0: CPM ENET Version 0.2, 08:00:22:50:70:63
-> PPP: version 2.3.10 (demand dialling)
-> TCP compression code copyright 1989 Regents of the
-> University of California
-> PPP line discipline registered.
-> Looking up port of RPC 100003/2 on 216.118.31.76
-> neighbour table overflow
-> neighbour table overflow
-> neighbour table overflow
-> eth0: transmit timed out.
->  Ring data dump: cur_tx ff0028d0 (full) cur_rx ff0028c8.
-> dc00 002a 0015c642
-> dc00 002a 0015c6e2
-> dc00 002a 0015c782
-> dc00 002a 0015c962
-> dc00 002a 0015ca02
-> dc00 002a 0015caa2
-> dc00 002a 0015c502
-> fc00 002a 0015cb42
-> 9c00 005a 00174000
-> 9c00 0076 00174800
-> 9c00 0076 00161000
-> 9c00 0076 00161800
-> 9c00 0040 00160000
-> 9c00 0040 00160000
-> 9c00 0076 0015f000
-> b000 7edd 0015f800
-> eth0: tx queue full!.
-> neighbour table overflow
-> eth0: transmit timed out.
->
-> and it goes on and on. After some time, it says server
-> returned error -5 and
-> then tries a reboot. What's going on???
->
-> Navin.
->
->

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/