[PATCH] powerpc/85xx: Add OCA4080 board support

[Martijn de Gouw]

On 04/15/2014 12:28 AM, Scott Wood wrote:
> On Mon, 2014-04-14 at 14:35 +0200, Martijn de Gouw wrote:
>> +	lbc: localbus at ffe124000 {
>> +		reg = <0xf 0xfe124000 0 0x1000>;
>> +		ranges = <0 0 0xf 0xef800000 0x800000>;
>> +
>> +		flash at 0,0 {
>> +			#address-cells = <1>;
>> +			#size-cells = <1>;
>> +			compatible = "cfi-flash";
>> +			reg = <0 0 0x00800000>;
>> +			bank-width = <2>;
>> +			device-width = <2>;
>> +			partition at rcw {
>> +				label = "rcw";
>> +				reg = <0x00000000 0x00020000>;
>> +			};
>> +			partition at fman-ucode {
>> +				label = "fman-ucode";
>> +				reg = <0x00020000 0x00020000>;
>> +			};
>> +			partition at user {
>> +				label = "user";
>> +				reg = <0x00040000 0x00680000>;
>> +			};
>> +			partition at env0 {
>> +				label = "env0";
>> +				reg = <0x006c0000 0x00020000>;
>> +			};
>> +			partition at env1 {
>> +				label = "env1";
>> +				reg = <0x006e0000 0x00020000>;
>> +			};
>> +			partition at u-boot {
>> +				label = "u-boot";
>> +				reg = <0x00700000 0x00080000>;
>> +			};
>> +			partition at u-boot-backup {
>> +				label = "u-boot-backup";
>> +				reg = <0x00780000 0x00080000>;
>> +			};
>
> These are not valid unit addresses.  Regardless, please don't put
> partition info in the dts.

How is this different than the partitions defined in i.e. p4080ds.dts?
Of course I can remove them from the dts, but where should they be defined?

-- 
Martijn de Gouw
Engineer
Prodrive Technologies B.V.
Mobile: +31 63 17 76 161
Phone:  +31 40 26 76 200