questions: second of the 2 pcie controllers does not scan the bus.

[Ruchika]

Any ideas/pointers anyone ?
Thank you
On 12/6/2013 6:48 PM, Ruchika wrote:
>
> Hi,
> I am working with an p4080 based board. I am trying to get 2 PCIE
> controllers probed properly.
>
> In uboot I have no problems scanning and discovering what is connected
> to both controllers/PCI bridges.
>
> For both PCIE1/2 uboot sets up the Primary, secondary and Subordinate
> bus numbers to 0,1,1 respectively.
>
> When linux boots up and probes the controllers, PCIE1 is probed and the
> bridge scanned properly but PCIE2 is probed at the bridge but not
> attempted a scan.
> I see this message
> "pci 0001:02:00.0: bridge configuration invalid ([bus 01-01]),
> reconfiguring
> "
>
> I updated uboot to set the secondary and subordinate numbers to 2 (left
> the primary number to 0) and a subsequent kernel boot scanned the bus
> for PCIE2 successfully.
> I found these numbers to be very critical since the device tree blob
> (bus-range) for pci is also based off these.
>
> I'd like to get a good fix rather than the uboot hack and get better
> understanding of the problem. If there are any pointers someone could
> provide it would be awesome.
>
> Thank you
> Regards
> Ruchika
>
>
>