[PATCH] powerpc/p1023: set IRQ[4:6, 11] to high level sensitive for PCIe

[Scott Wood]

On 11/07/2011 11:51 PM, Zang Roy-R61911 wrote:
> 
> 
>> -----Original Message-----
>> From: Wood Scott-B07421
>> Sent: Tuesday, November 08, 2011 2:44 AM
>> To: Zang Roy-R61911
>> Cc: linuxppc-dev at lists.ozlabs.org
>> Subject: Re: [PATCH] powerpc/p1023: set IRQ[4:6, 11] to high level sensitive for
>> PCIe
>>
>> On 11/07/2011 02:32 AM, Roy Zang wrote:
>>> P1023 external IRQ[4:6, 11] do not pin out, but the interrupts are
>>> shared with PCIe controller.
>>> The silicon internally ties the interrupts to L, so change the
>>> IRQ[4:6,11] to high level sensitive for PCIe.
>>
>> Some extra commentary on why this works would be nice.
> I do not know what kind of extra commentary you request. 

Just a note that there's magic to allow the PCIe block to output these
interrupts as either active-high or active-low, depending on how they're
configured at the mpic.

> IRQ 4,5,6, 11 are internally tie to low by silicon. To use these interrupts for PCIe, they need to set high level sensitive.
> It is clear enough for this patch.

It's odd enough that I felt the need to go reading through the docs to
see why such a thing would work at all.

>> The manual says:
>>
>>> If a PCI Express INTx interrupt is being used, then the PIC must be configured
>> so that external interrupts
>>> are level-sensitive (EIVPRn[S] = 1).
> That is true for all FSL powerpc silicon with PCIe controller beside P1023.

Sure, my point was more that it didn't say anything there about how to
configure EIVPRn[P].

-Scott