[PATCH 1/8] pseries: phyp dump: Docmentation
Michael Ellerman
michael at ellerman.id.au
Wed Jan 9 15:58:35 EST 2008
On Tue, 2008-01-08 at 22:29 -0600, Nathan Lynch wrote:
> Manish Ahuja wrote:
> > +
> > + Hypervisor-Assisted Dump
> > + ------------------------
> > + November 2007
>
> Date is unneeded (and, uhm, dated :)
>
>
> > +The goal of hypervisor-assisted dump is to enable the dump of
> > +a crashed system, and to do so from a fully-reset system, and
> > +to minimize the total elapsed time until the system is back
> > +in production use.
>
> Is it actually faster than kdump?
>
>
> > +As compared to kdump or other strategies, hypervisor-assisted
> > +dump offers several strong, practical advantages:
> > +
> > +-- Unlike kdump, the system has been reset, and loaded
> > + with a fresh copy of the kernel. In particular,
> > + PCI and I/O devices have been reinitialized and are
> > + in a clean, consistent state.
> > +-- As the dump is performed, the dumped memory becomes
> > + immediately available to the system for normal use.
> > +-- After the dump is completed, no further reboots are
> > + required; the system will be fully usable, and running
> > + in it's normal, production mode on it normal kernel.
> > +
> > +The above can only be accomplished by coordination with,
> > +and assistance from the hypervisor. The procedure is
> > +as follows:
> > +
> > +-- When a system crashes, the hypervisor will save
> > + the low 256MB of RAM to a previously registered
> > + save region. It will also save system state, system
> > + registers, and hardware PTE's.
> > +
> > +-- After the low 256MB area has been saved, the
> > + hypervisor will reset PCI and other hardware state.
> > + It will *not* clear RAM. It will then launch the
> > + bootloader, as normal.
> > +
> > +-- The freshly booted kernel will notice that there
> > + is a new node (ibm,dump-kernel) in the device tree,
> > + indicating that there is crash data available from
> > + a previous boot. It will boot into only 256MB of RAM,
> > + reserving the rest of system memory.
> > +
> > +-- Userspace tools will parse /sys/kernel/release_region
> > + and read /proc/vmcore to obtain the contents of memory,
> > + which holds the previous crashed kernel. The userspace
> > + tools may copy this info to disk, or network, nas, san,
> > + iscsi, etc. as desired.
> > +
> > + For Example: the values in /sys/kernel/release-region
> > + would look something like this (address-range pairs).
> > + CPU:0x177fee000-0x10000: HPTE:0x177ffe020-0x1000: /
> > + DUMP:0x177fff020-0x10000000, 0x10000000-0x16F1D370A
> > +
> > +-- As the userspace tools complete saving a portion of
> > + dump, they echo an offset and size to
> > + /sys/kernel/release_region to release the reserved
> > + memory back to general use.
> > +
> > + An example of this is:
> > + "echo 0x40000000 0x10000000 > /sys/kernel/release_region"
> > + which will release 256MB at the 1GB boundary.
>
> This violates the "one file, one value" rule of sysfs, but nobody
> really takes that seriously, I guess. In any case, consider
> documenting this in Documentation/ABI.
>
>
> > +
> > +Please note that the hypervisor-assisted dump feature
> > +is only available on Power6-based systems with recent
> > +firmware versions.
>
> This statement will of course become dated/incorrect so I recommend
> removing it.
>
>
> > +
> > +Implementation details:
> > +----------------------
> > +In order for this scheme to work, memory needs to be reserved
> > +quite early in the boot cycle. However, access to the device
> > +tree this early in the boot cycle is difficult, and device-tree
> > +access is needed to determine if there is a crash data waiting.
>
> I don't think this bit about early device tree access is correct. By
> the time your code is reserving memory (from early_init_devtree(), I
> think), RTAS has been instantiated and you are able to test for the
> existence of /rtas/ibm,dump-kernel.
Yep it's early_init_devtree(), and yes it's fairly easy to access the
(flattened) device tree at that point.
> > +To work around this problem, all but 256MB of RAM is reserved
> > +during early boot. A short while later in boot, a check is made
> > +to determine if there is dump data waiting. If there isn't,
> > +then the reserved memory is released to general kernel use.
>
> So I think these gymnastics are unneeded -- unless I'm
> misunderstanding something, you should be able to determine very early
> whether to reserve that memory.
I agree.
cheers
--
Michael Ellerman
OzLabs, IBM Australia Development Lab
wwweb: http://michael.ellerman.id.au
phone: +61 2 6212 1183 (tie line 70 21183)
We do not inherit the earth from our ancestors,
we borrow it from our children. - S.M.A.R.T Person
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: application/pgp-signature
Size: 189 bytes
Desc: This is a digitally signed message part
URL: <http://lists.ozlabs.org/pipermail/linuxppc-dev/attachments/20080109/a1ffd59c/attachment.pgp>
More information about the Linuxppc-dev
mailing list