[SLOF] Loading file from disk image

[Jd Lyons]

> On Jan 2, 2018, at 4:35 AM, Thomas Huth <thuth at redhat.com> wrote:
> 
> On 29.12.2017 10:09, Jd Lyons wrote:
> [...]
>> Now if there was only a byte-load word:-(
> 
> The FCode interpreter is currently disabled in SLOF by default - since
> nobody was actively using it in years and pulling in all the required
> Forth code slowed down the boot process quite a bit.
> 
> But you can enable it manually by typing this at the firmware prompt:
> 
> include evaluator.fs
> 
> After that, the "byte-load" word should be available.
> I hope that's good enough for your experiments ... if there's a real
> good reason for enabling it permanently again, please let us know, then
> we should maybe come up with a better solution for this...
> 
> Thomas

Thanks Tom, is there a way to enable fcode-verbose?

Also trying to change to load-base always seem to end up with 3d0900, rather than what I try and set it too.

Setenv load-base 8000000