[Skiboot] [PATCH V3 4/5] NX: Add P9 NX support for gzip compression engine
Haren Myneni
haren at linux.vnet.ibm.com
Sat Apr 1 18:18:20 AEDT 2017
[PATCH V3 4/5] NX: Add P9 NX support for gzip compression engine
Power 9 introduces NX gzip compression engine. This patch adds gzip
compression support in NX. Virtual Accelerator Switch (VAS) is used to
access NX gzip engine and the channel configuration will be done with
the receive FIFO. So RxFIFO address, logical partition ID (lpid),
process ID (pid) and thread ID (tid) are used to configure RxFIFO.
P9 NX supports high and normal priority FIFOS. Skiboot configures User
Mode Access Control (UMAC) noitify match register with these values and
also enables other registers to enable / disable the engine.
Creates the following device-tree entries to provide RxFIFO address,
lpid, pid and tid values so that kernel can drive P9 NX gzip engine.
The following nodes are located under an xscom node:
/xscom@<xscom_addr>/nx@<nx_addr>
/ibm,nx-gzip-high : High priority gzip RxFIFO
/ibm,nx-gzip-normal : Normal priority gzip RxFIFO
Each RxFIFO node contains:
rx-fifo-address : RxFIFO address
lpid : 0xfff (1's for 12 bits in UMAC notify match
regsiter)
pid : gzip coprocessor type
tid : counter for gzip
Signed-off-by: Haren Myneni <haren at us.ibm.com>
---
hw/Makefile.inc | 2 +-
hw/nx-compress.c | 1 +
hw/nx-gzip.c | 127 ++++++++++++++++++++++++++++++++++++++++++++++++++++++
include/nx.h | 1 +
4 files changed, 130 insertions(+), 1 deletions(-)
create mode 100644 hw/nx-gzip.c
diff --git a/hw/Makefile.inc b/hw/Makefile.inc
index 97c909e..d4c4fcc 100644
--- a/hw/Makefile.inc
+++ b/hw/Makefile.inc
@@ -2,7 +2,7 @@
SUBDIRS += hw
HW_OBJS = xscom.o chiptod.o gx.o cec.o lpc.o lpc-uart.o psi.o
HW_OBJS += homer.o slw.o occ.o fsi-master.o centaur.o
-HW_OBJS += nx.o nx-rng.o nx-crypto.o nx-compress.o nx-842.o
+HW_OBJS += nx.o nx-rng.o nx-crypto.o nx-compress.o nx-842.o nx-gzip.o
HW_OBJS += p7ioc.o p7ioc-inits.o p7ioc-phb.o
HW_OBJS += phb3.o sfc-ctrl.o fake-rtc.o bt.o p8-i2c.o prd.o
HW_OBJS += dts.o lpc-rtc.o npu.o npu-hw-procedures.o xive.o phb4.o
diff --git a/hw/nx-compress.c b/hw/nx-compress.c
index 9970d55..674fd4a 100644
--- a/hw/nx-compress.c
+++ b/hw/nx-compress.c
@@ -217,6 +217,7 @@ void nx_create_compress_node(struct dt_node *node)
return;
p9_nx_enable_842(node, gcid, pb_base);
+ p9_nx_enable_gzip(node, gcid, pb_base);
} else
nx_enable_842(node, gcid, pb_base);
}
diff --git a/hw/nx-gzip.c b/hw/nx-gzip.c
new file mode 100644
index 0000000..8b384f1
--- /dev/null
+++ b/hw/nx-gzip.c
@@ -0,0 +1,127 @@
+/* Copyright 2016 IBM Corp.
+ *
+ * Licensed under the Apache License, Version 2.0 (the "License");
+ * you may not use this file except in compliance with the License.
+ * You may obtain a copy of the License at
+ *
+ * http://www.apache.org/licenses/LICENSE-2.0
+ *
+ * Unless required by applicable law or agreed to in writing, software
+ * distributed under the License is distributed on an "AS IS" BASIS,
+ * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or
+ * implied.
+ * See the License for the specific language governing permissions and
+ * limitations under the License.
+ */
+
+#include <skiboot.h>
+#include <chip.h>
+#include <xscom.h>
+#include <io.h>
+#include <cpu.h>
+#include <nx.h>
+
+#define EE (1) /* enable gzip engine */
+
+static int nx_cfg_gzip_umac(struct dt_node *node, u32 gcid, u32 pb_base)
+{
+ int rc;
+ u64 umac_bar, umac_ctrl, umac_notify;
+ struct dt_node *nx_node;
+ static u32 nxgzip_tid = 1; /* tid counter within coprocessor type */
+
+ nx_node = dt_new(node, "ibm,nx-gzip-high");
+ umac_bar = pb_base + NX_P9_GZIP_HIGH_PRI_RX_FIFO_BAR;
+ umac_ctrl = pb_base + NX_P9_GZIP_HIGH_PRI_RX_FIFO_CTRL;
+ umac_notify = pb_base + NX_P9_GZIP_HIGH_PRI_RX_FIFO_NOTIFY_MATCH;
+
+ rc = nx_cfg_rx_fifo(nx_node, gcid, umac_bar, umac_notify, umac_ctrl,
+ NX_CT_GZIP, nxgzip_tid++);
+ if (rc)
+ return rc;
+
+ nx_node = dt_new(node, "ibm,nx-gzip-normal");
+ umac_bar = pb_base + NX_P9_GZIP_NORMAL_PRI_RX_FIFO_BAR;
+ umac_ctrl = pb_base + NX_P9_GZIP_NORMAL_PRI_RX_FIFO_CTRL;
+ umac_notify = pb_base + NX_P9_GZIP_NORMAL_PRI_RX_FIFO_NOTIFY_MATCH;
+
+ rc = nx_cfg_rx_fifo(nx_node, gcid, umac_bar, umac_notify, umac_ctrl,
+ NX_CT_GZIP, nxgzip_tid++);
+
+ return rc;
+}
+
+static int nx_cfg_gzip_dma(u32 gcid, u64 xcfg)
+{
+ u64 cfg;
+ int rc;
+
+ rc = xscom_read(gcid, xcfg, &cfg);
+ if (rc)
+ return rc;
+
+ cfg = SETFIELD(NX_DMA_CFG_GZIP_COMPRESS_PREFETCH, cfg,
+ DMA_COMPRESS_PREFETCH);
+ cfg = SETFIELD(NX_DMA_CFG_GZIP_DECOMPRESS_PREFETCH, cfg,
+ DMA_DECOMPRESS_PREFETCH);
+
+ cfg = SETFIELD(NX_DMA_CFG_GZIP_COMPRESS_MAX_RR, cfg,
+ DMA_COMPRESS_MAX_RR);
+ cfg = SETFIELD(NX_DMA_CFG_GZIP_DECOMPRESS_MAX_RR, cfg,
+ DMA_DECOMPRESS_MAX_RR);
+
+ rc = xscom_write(gcid, xcfg, cfg);
+ if (rc)
+ prerror("NX%d: ERROR: DMA config failure %d\n", gcid, rc);
+ else
+ prlog(PR_DEBUG, "NX%d: DMA 0x%016lx\n", gcid,
+ (unsigned long)cfg);
+
+ return rc;
+}
+
+static int nx_cfg_gzip_ee(u32 gcid, u64 xcfg)
+{
+ u64 cfg;
+ int rc;
+
+ rc = xscom_read(gcid, xcfg, &cfg);
+ if (rc)
+ return rc;
+
+ cfg = SETFIELD(NX_P9_EE_CFG_CH4, cfg, EE);
+
+ rc = xscom_write(gcid, xcfg, cfg);
+ if (rc)
+ prerror("NX%d: ERROR: Engine Enable failure %d\n", gcid, rc);
+ else
+ prlog(PR_DEBUG, "NX%d: Engine Enable 0x%016lx\n",
+ gcid, (unsigned long)cfg);
+
+ return rc;
+}
+
+void p9_nx_enable_gzip(struct dt_node *node, u32 gcid, u32 pb_base)
+{
+ u64 cfg_dma, cfg_ee;
+ int rc;
+
+ prlog(PR_INFO, "NX%d: gzip at 0x%x\n", gcid, pb_base);
+
+ cfg_dma = pb_base + NX_P9_DMA_CFG;
+ cfg_ee = pb_base + NX_P9_EE_CFG;
+
+ rc = nx_cfg_gzip_dma(gcid, cfg_dma);
+ if (rc)
+ return;
+
+ rc = nx_cfg_gzip_ee(gcid, cfg_ee);
+ if (rc)
+ return;
+
+ rc = nx_cfg_gzip_umac(node, gcid, pb_base);
+ if (rc)
+ return;
+
+ prlog(PR_INFO, "NX%d: gzip Coprocessor Enabled\n", gcid);
+}
diff --git a/include/nx.h b/include/nx.h
index ada5157..8582b2f 100644
--- a/include/nx.h
+++ b/include/nx.h
@@ -405,6 +405,7 @@ extern void nx_create_compress_node(struct dt_node *);
extern void nx_enable_842(struct dt_node *node, u32 gcid, u32 pb_base);
extern void p9_nx_enable_842(struct dt_node *node, u32 gcid, u32 pb_base);
+extern void p9_nx_enable_gzip(struct dt_node *node, u32 gcid, u32 pb_base);
extern int nx_cfg_rx_fifo(struct dt_node *node, u32 gcid, u64 umac_bar,
u64 umac_notify, u64 umac_ctrl, u32 pid,
--
1.7.1
More information about the Skiboot
mailing list