[PATCH linux dev-5.3 2/4] clocksource: fttmr010: Parametrise shutdown

[Joel Stanley]

In preparation for supporting the ast2600 which uses a different method
to clear bits in the control register, use a callback for performing the
shutdown sequence.

Signed-off-by: Joel Stanley <joel at jms.id.au>
---
 drivers/clocksource/timer-fttmr010.c | 19 ++++++++-----------
 1 file changed, 8 insertions(+), 11 deletions(-)

diff --git a/drivers/clocksource/timer-fttmr010.c b/drivers/clocksource/timer-fttmr010.c
index fadff7915dd9..c2d30eb9dc72 100644
--- a/drivers/clocksource/timer-fttmr010.c
+++ b/drivers/clocksource/timer-fttmr010.c
@@ -97,6 +97,7 @@ struct fttmr010 {
 	bool is_aspeed;
 	u32 t1_enable_val;
 	struct clock_event_device clkevt;
+	int (*timer_shutdown)(struct clock_event_device *evt);
 #ifdef CONFIG_ARM
 	struct delay_timer delay_timer;
 #endif
@@ -140,9 +141,7 @@ static int fttmr010_timer_set_next_event(unsigned long cycles,
 	u32 cr;
 
 	/* Stop */
-	cr = readl(fttmr010->base + TIMER_CR);
-	cr &= ~fttmr010->t1_enable_val;
-	writel(cr, fttmr010->base + TIMER_CR);
+	fttmr010->timer_shutdown(evt);
 
 	if (fttmr010->is_aspeed) {
 		/*
@@ -183,9 +182,7 @@ static int fttmr010_timer_set_oneshot(struct clock_event_device *evt)
 	u32 cr;
 
 	/* Stop */
-	cr = readl(fttmr010->base + TIMER_CR);
-	cr &= ~fttmr010->t1_enable_val;
-	writel(cr, fttmr010->base + TIMER_CR);
+	fttmr010->timer_shutdown(evt);
 
 	/* Setup counter start from 0 or ~0 */
 	writel(0, fttmr010->base + TIMER1_COUNT);
@@ -211,9 +208,7 @@ static int fttmr010_timer_set_periodic(struct clock_event_device *evt)
 	u32 cr;
 
 	/* Stop */
-	cr = readl(fttmr010->base + TIMER_CR);
-	cr &= ~fttmr010->t1_enable_val;
-	writel(cr, fttmr010->base + TIMER_CR);
+	fttmr010->timer_shutdown(evt);
 
 	/* Setup timer to fire at 1/HZ intervals. */
 	if (fttmr010->is_aspeed) {
@@ -350,6 +345,8 @@ static int __init fttmr010_common_init(struct device_node *np, bool is_aspeed)
 				     fttmr010->tick_rate);
 	}
 
+	fttmr010->timer_shutdown = fttmr010_timer_shutdown;
+
 	/*
 	 * Setup clockevent timer (interrupt-driven) on timer 1.
 	 */
@@ -370,10 +367,10 @@ static int __init fttmr010_common_init(struct device_node *np, bool is_aspeed)
 	fttmr010->clkevt.features = CLOCK_EVT_FEAT_PERIODIC |
 		CLOCK_EVT_FEAT_ONESHOT;
 	fttmr010->clkevt.set_next_event = fttmr010_timer_set_next_event;
-	fttmr010->clkevt.set_state_shutdown = fttmr010_timer_shutdown;
+	fttmr010->clkevt.set_state_shutdown = fttmr010->timer_shutdown;
 	fttmr010->clkevt.set_state_periodic = fttmr010_timer_set_periodic;
 	fttmr010->clkevt.set_state_oneshot = fttmr010_timer_set_oneshot;
-	fttmr010->clkevt.tick_resume = fttmr010_timer_shutdown;
+	fttmr010->clkevt.tick_resume = fttmr010->timer_shutdown;
 	fttmr010->clkevt.cpumask = cpumask_of(0);
 	fttmr010->clkevt.irq = irq;
 	clockevents_config_and_register(&fttmr010->clkevt,
-- 
2.24.0.rc1