using phosphor-dbus-monitor

[Matt Spinler]

Hi Wim,

If you could post your YAML somewhere, I could take a look for any 
obvious problems.

On 4/9/2019 2:23 AM, Wim Vervoorn wrote:
> Hello Lei,
>
> Thanks for your response. I know this example too and it helps a bit but it doesn’t really clarify all issues.
>
> As you've worked with this as well. Do you understand the meta item? The example indicates it has different meaning but doesn't provide any pointers to what those meanings are. Have you been able to find out?
>
> Best Regards,
> Wim Vervoorn
>
> -----Original Message-----
> From: Lei YU [mailto:mine260309 at gmail.com]
> Sent: Tuesday, April 9, 2019 5:44 AM
> To: Wim Vervoorn <wvervoorn at eltan.com>; Matthew Barth <msbarth at linux.ibm.com>
> Cc: openbmc at lists.ozlabs.org
> Subject: Re: using phosphor-dbus-monitor
>
>> I am trying to use phosphor-dbus-monitor to create logging of sensor exceptions like a Critical state on a specific sensor.
>> I am able to create a solution with a building yaml but at the end it doesn’t deliver me the desired result.
>> As there are very limited examples (on a few in the witherspoon) it is very hard to figure out where the mistake is.
> There is an example yaml config in the repo:
> https://github.com/openbmc/phosphor-dbus-monitor/blob/master/src/example/example.yaml
>
> And I have the same feeling that it's hard to know what's wrong if something is wrong.ei
>
>> Are there any tools that can be used to make this easier?
> @Matthew Barth Could you kindly help to add some doc/tool to make it easier to use?
>
>> Additionally is this the correct method to achieve this goal or should I use something else to define conditions for logging?
> I think so. This repo is intended to watch the dbus and do stuff as yaml config.
>
>