[PATCH linux v2] pinctrl-aspeed-g5: Never set SCU90[6]

[Andrew Jeffery]

If a pin depending on bit 6 in SCU90 is requested for GPIO, the export
will succeed but changes to the GPIO's value will not be accepted by the
hardware. This is because the pinmux driver has misconfigured the SCU by
writing 1 to the reserved bit.

The description of SCU90[6] from the datasheet is 'Reserved, must keep
at value ”0”'. The fix is to switch pinmux from the bit-flipping macro
to explicitly configuring the .enable and .disable values to zero.

The patch has been tested on an AST2500 EVB.

Reported-by: Uma Yadlapati <yadlapat at us.ibm.com>
Signed-off-by: Andrew Jeffery <andrew at aj.id.au>
---
 drivers/pinctrl/aspeed/pinctrl-aspeed-g5.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/pinctrl/aspeed/pinctrl-aspeed-g5.c b/drivers/pinctrl/aspeed/pinctrl-aspeed-g5.c
index 481e836d12e5..9a3139c13ffc 100644
--- a/drivers/pinctrl/aspeed/pinctrl-aspeed-g5.c
+++ b/drivers/pinctrl/aspeed/pinctrl-aspeed-g5.c
@@ -26,7 +26,7 @@
 
 #define ASPEED_G5_NR_PINS 232
 
-#define COND1		SIG_DESC_BIT(SCU90, 6, 0)
+#define COND1		{ SCU90, BIT(6), 0, 0 }
 #define COND2		{ SCU94, GENMASK(1, 0), 0, 0 }
 
 #define LHCR0		SIG_DESC_TO_REG(ASPEED_IP_LPC, 0xA0)
-- 
2.7.4