[PATCH 0/6] Firestone patches

[Cyril Bur]

Did some work getting openbmc running on a Firestone. These should
also work for a Garrison, the firestone.dts is probably good for that
too.

Thanks very much to Gavin for getting networking going.

These patches are the outcome based on dev-4.4.

Cyril Bur (2):
  arm/dts: Set I2C_TEN_BIT_ADDRESS in Firestone BMC board i2c addresses
  arm/dts: Remove mac hardware checksum from Firestone BMC Board

Gavin Shan (1):
  net/phy: Expose 100base-T capability only

Joel Stanley (3):
  phy/broadcom: Add support for the BCM54210E
  arm/dts/aspeed: Move mac nsci properties
  arm/dts: Add Firestone BMC board

 arch/arm/boot/dts/aspeed-bmc-opp-barreleye.dts |   5 +
 arch/arm/boot/dts/aspeed-bmc-opp-firestone.dts | 136 +++++++++++++++++++++++++
 arch/arm/boot/dts/aspeed-bmc-opp-palmetto.dts  |   5 +
 arch/arm/boot/dts/ast2400.dtsi                 |   6 +-
 drivers/net/phy/broadcom.c                     |  13 +++
 include/linux/brcmphy.h                        |   2 +
 6 files changed, 165 insertions(+), 2 deletions(-)
 create mode 100644 arch/arm/boot/dts/aspeed-bmc-opp-firestone.dts

-- 
2.8.2