2.6 system stuck with one line change in platform_init()

[Michael.Kang]

On 8/11/07, mike zheng <mail4mz at gmail.com> wrote:
> Hi All,
>
> In order to debug the 8548 CDS BSP of kernel 2.6, I want setup serial port
> with UART on mpc85xx as early as possible. . I add the register access code
> at the beginning of  platform_init(). However the system just hanging there
> with this line. If I comment out this
> line"WRITE8_ADDR(M85xx_EIIADDR,0)", then linux kernel runs
> well.
>
> Thanks in advance,
>
> Mike Z
>
> Here is the code of my mpc85xx_cds_common.c:
>
> #define WRITE8_ADDR(address, value) \
>     ((*((volatile u8 *)(address))) = (u8)(value))
>
> #define M85xx_EII_ADDR 0xe0004500
>
> void __init
> platform_init(unsigned long r3, unsigned long r4, unsigned long r5,
>                    unsigned long r6, unsigned long r7)
> {
>        /* parse_bootinfo must always be called first */
>        parse_bootinfo(find_bootinfo());
>
>       /* Now we try to access register of UART */
>       WRITE8_ADDR(M85xx_EII_ADDR, 0);
         where is M85xx_EII_ADDR declearation? If the address need to
be io_remap first?
> ....
> }
> _______________________________________________
> Linuxppc-embedded mailing list
> Linuxppc-embedded at ozlabs.org
> https://ozlabs.org/mailman/listinfo/linuxppc-embedded
>


-- 
www.skyeye.org