Using bestcomm in an external module (MPC5200B to be exact)

Trueskew trueskew at gmail.com
Sat Jun 17 14:47:09 EST 2006


I'm writing a driver for a TI codec attached to the MPC5200B PSC3 codec
lines on a Lite5200b.  It's an external module, and I'd like to use Bestcomm
with it.  I've already tried a bunch of horrible things to get it to work.
I could say it's close, but by close I mean the FEC still runs, my stuff
doesn't.  
 
1. Can the Bestcomm I/F be used by an external module, or is the module
required to be built in if built-in drivers use Bestcomm?  TasksInitAPI (no
so bad) and TasksLoadImage (yeah, bad) aren't really supposed to be called
more than once from what I've read, and the kernel loads them for ethernet
and ATA (no disk in my system if that matters).  
 
2. If it can be used by an external module, how would I do it?  I've tried
compiling the source into my module and replicating the initialization the
kernel does in addition to my own stuff.  It's not too bad, though I don't
get any interrupts yet.
 
The LTIB from Freescale includes AIC23 and AC97 drivers that use Bestcomm.
I built my kernel with them set as modules, and they had the same unresolved
problems that my driver has on insmod, so I'm pessimistic.  If someone could
put me out of my misery one way or another, I'd appreciate it.
 
Thanks.
Sal
 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://ozlabs.org/pipermail/linuxppc-embedded/attachments/20060616/e609d301/attachment.htm 


More information about the Linuxppc-embedded mailing list