fs_enet on MPC885ADS

[Schaefer-Hutter, Peter]

Hi there,

Are there any boot options needed to enable the fs_enet driver
on the MPC885ADS? I replaced CONFIG_DUET with CONFIG_MPC885ADS
in drivers/net/fs_enet/mac-fec.c, but only got

  fs_enet.c:v0.1 (May 6, 2005)
  NET: Registered protocol family 2
  IP route cache hash table entries: 128 (order: -3, 512 bytes)
  TCP established hash table entries: 512 (order: 0, 4096 bytes)
  TCP bind hash table entries: 512 (order: -1, 2048 bytes)
  TCP: Hash tables configured (established 512 bind 512)
  TCP reno registered
  TCP bic registered
  NET: Registered protocol family 1
  NET: Registered protocol family 17
  IP-Config: Device `eth0' not found.

Reason i'm asking is that the current cpm_uart driver doesn't work
with the SCC3 ethernet driver included in the MPC885 board support
(as soon as ethernet is initialized, console output stops).

Best regards,

 Peter