MPC885ADS and 2.6.13-rc5 - nogo ?

[Vitaly Bordug]

Schaefer-Hutter, Peter wrote:

>Hello,
>
>  
>
>>From: Vitaly Bordug [mailto:vbordug at ru.mvista.com] 
>>    
>>
>
>  
>
>>The board does not hang - there's somithing with 
>>console since you don't see anything.  Try to change 
>>BCSR_ADDR from 0xf4500000 to 0xf80...0 - the newer 
>>version of the boards may have this changed.
>>    
>>
>
>Hrm... arc/ppc/mpc885ads.h already reads
>
>  /* U-Boot maps BCSR to 0xff080000 */
>  #define BCSR_ADDR   ((uint)0xff080000)
>
>And that's the same setting that my 2.4-Kernel
>uses, so it should work with 0xff080000.
>
>However, BCSR_SIZE looks suspicious in this header:
>
>  #define BCSR_SIZE   ((uint)32)
>
>Shouldn't that read:
>
>  #define BCSR_SIZE   ((uint)32 * 1024)
>
>??!?
>
>Regards,
>
>  Peter
>
>  
>
<quotation> (This is from 8272 User Guide, but 885 I guess is the same 
in this part)

> Most of the hardware options on the MPC8272ADS are controlled or 
> monitored by the
> BCSR, which is a 32 bit wide read / write register file. The BCSR is 
> accessed via the
> MPC8272s' memory controller (see Table 5-5) and in fact includes 8 
> registers: BCSR0 to
> BCSR7. Since the minimum block size for a CS region is 32KBytes and 
> only A(27:29)
> lines are decoded by the BCSR for register selection, BCSR0 - BCSR7 
> are duplicated inside
> that region.

<quotation\>

-- 
Sincerely, 
Vitaly

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://ozlabs.org/pipermail/linuxppc-embedded/attachments/20050803/a0e15793/attachment.htm