help needed for porting linux-2.5 to a ppc custom board

[Ricardo Scop]

Atm :-),

A good starting point is
http://penguinppc.org/embedded/howto/PowerPC-Embedded-HOWTO.html.

IMHO, porting a good bootloader/monitor to your board, like PPCBoot,
is half the way to go.

I hope that helps...

Ricardo Scop                            mailto:scop at plugin.com.br

------------------------------------------------------------------
It might look like I'm doing nothing, but at the cellular level I'm
really quite busy.

Saturday, September 14, 2002, 4:34:28 AM, you wrote:

Aa>   We want to run linux on a custom board having ppc603ev.
Aa> We have identified the following tasks :-
Aa> processor-specific tuning,
Aa> board related changes (io_block_mapping, pic etc.)
Aa> serial driver for uart device.
Aa> pci,timer initialisations.

Aa>   There is 4mb flash on the board (for storing vmlinux.gz)
Aa> No hard disk.

Aa>  Since, there is only 1 uart port, how can we use it for
Aa> console-login and dumping printk messages?

Aa>  How should we start identifying changes to be done in
Aa> kernel source (mostly arch/ppc)? Is there any resource
Aa> available on internet for porting linux to a powerpc/any
Aa> board ?

** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/