PCMCIA on an MPC860

[Alex Zeffertt]

All,

Has anybody had any luck getting PCMCIA to work on an MPC860?

I have a custom MPC860 board, with a single PCMCIA socket connected to Slot B.  This is what I have
so far done:

1.
Downloaded pcmcia-cs-3.2.0.tar.gz
2.
Added board specific definitions in modules/m8xx_pcmcia.c for
		hardware_enable()
		hardware_disable()
		voltage_set()
		socket_get()
3.
Cross compiled for the 8xx.
4.
In my kernel (linux-2.4.4-2001-11-24 from Denx) I added the following lines
		include/asm-ppc/<board>.h:
			/* define IO_BASE for pcmcia */
			#define _IO_BASE 0x80000000
			#define _IO_BASE_SIZE (1024*64)
		arch/ppc/mm/init.c:
			void __init MMU_init(void) {
			...
			ioremap(_IO_BASE,_IO_BASE_SIZE);


	...as suggested by Magnus Damm in
	http://lists.linuxppc.org/linuxppc-embedded/200005/msg00227.html


HOWEVER,

5. 	When I boot my board with a Flash card in the PCMCIA slot, and I run:
	/etc/rc.d/rc.pcmcia start
	I find that ide_cs.o causes an Oops when it calls ide_register().  "cardctl status"
	and "cardctl ident" work though.


Can anybody suggest what I'm doing wrong?

Thanks in advance,

Alex


** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/