CS_BAD_VCC Error during Card Configaration.
David Gibson
david at gibson.dropbear.id.au
Mon Aug 5 15:27:07 EST 2002
On Mon, Aug 05, 2002 at 04:30:39AM -0000, Narendra wrote:
>
> Hi.
>
> I am involved in porting WLAN driver to Embedded Planet RPX-LITE
> board.
>
> I am using HHL - 2,4,2 and Pcmcia-cs (3.1.24). When i insert
> D-Link DWL 350 prism2 card (intersil) my driver is invoked by
> cardmgr.
>
> But as i found through debug message, socket is configured for
> 5volts and the CIS read from my card wants 3.3V. So my Config()
> routine is failing since there is a mismatch in configured Vcc and
> Requested Vcc. and Kernel is crashing.
>
> Where i need to do modification to configure EP socket for 3.3v?
>
> Should i need to make any modification in m8xx_pcmcia.c?
>
> I didn`t come across this problem when i tested my driver in
> Compaq Armada notebook.
>
> I am struck at this point. All inputs are welcome.
Which wireless driver are you using?
--
David Gibson | For every complex problem there is a
david at gibson.dropbear.id.au | solution which is simple, neat and
| wrong.
http://www.ozlabs.org/people/dgibson
** Sent via the linuxppc-embedded mail list. See http://lists.linuxppc.org/
More information about the Linuxppc-embedded
mailing list