[PATCH v3 32/45] powerpc/8xx: Always pin TLBs at startup.
Christophe Leroy
christophe.leroy at csgroup.eu
Mon May 11 21:25:58 AEST 2020
At startup, map 32 Mbytes of memory through 4 pages of 8M,
and PIN them inconditionnaly. They need to be pinned because
KASAN is using page tables early and the TLBs might be
dynamically replaced otherwise.
Remove RSV4I flag after installing mappings unless
CONFIG_PIN_TLB_XXXX is selected.
Signed-off-by: Christophe Leroy <christophe.leroy at csgroup.eu>
---
arch/powerpc/kernel/head_8xx.S | 31 +++++++++++++++++--------------
arch/powerpc/mm/nohash/8xx.c | 19 +------------------
2 files changed, 18 insertions(+), 32 deletions(-)
diff --git a/arch/powerpc/kernel/head_8xx.S b/arch/powerpc/kernel/head_8xx.S
index d607f4b53e0f..b0cceee6405c 100644
--- a/arch/powerpc/kernel/head_8xx.S
+++ b/arch/powerpc/kernel/head_8xx.S
@@ -765,6 +765,14 @@ start_here:
mtspr SPRN_MD_RPN, r0
lis r0, (MD_TWAM | MD_RSV4I)@h
mtspr SPRN_MD_CTR, r0
+#endif
+#ifndef CONFIG_PIN_TLB_TEXT
+ li r0, 0
+ mtspr SPRN_MI_CTR, r0
+#endif
+#if !defined(CONFIG_PIN_TLB_DATA) && !defined(CONFIG_PIN_TLB_IMMR)
+ lis r0, MD_TWAM at h
+ mtspr SPRN_MD_CTR, r0
#endif
tlbia /* Clear all TLB entries */
sync /* wait for tlbia/tlbie to finish */
@@ -802,10 +810,6 @@ initial_mmu:
mtspr SPRN_MD_CTR, r10 /* remove PINNED DTLB entries */
tlbia /* Invalidate all TLB entries */
-#ifdef CONFIG_PIN_TLB_DATA
- oris r10, r10, MD_RSV4I at h
- mtspr SPRN_MD_CTR, r10 /* Set data TLB control */
-#endif
lis r8, MI_APG_INIT at h /* Set protection modes */
ori r8, r8, MI_APG_INIT at l
@@ -814,33 +818,32 @@ initial_mmu:
ori r8, r8, MD_APG_INIT at l
mtspr SPRN_MD_AP, r8
- /* Now map the lower RAM (up to 32 Mbytes) into the ITLB. */
-#ifdef CONFIG_PIN_TLB_TEXT
+ /* Map the lower RAM (up to 32 Mbytes) into the ITLB and DTLB */
lis r8, MI_RSV4I at h
ori r8, r8, 0x1c00
-#endif
+ oris r12, r10, MD_RSV4I at h
+ ori r12, r12, 0x1c00
li r9, 4 /* up to 4 pages of 8M */
mtctr r9
lis r9, KERNELBASE at h /* Create vaddr for TLB */
li r10, MI_PS8MEG | MI_SVALID /* Set 8M byte page */
li r11, MI_BOOTINIT /* Create RPN for address 0 */
- lis r12, _einittext at h
- ori r12, r12, _einittext at l
1:
-#ifdef CONFIG_PIN_TLB_TEXT
mtspr SPRN_MI_CTR, r8 /* Set instruction MMU control */
addi r8, r8, 0x100
-#endif
-
ori r0, r9, MI_EVALID /* Mark it valid */
mtspr SPRN_MI_EPN, r0
mtspr SPRN_MI_TWC, r10
mtspr SPRN_MI_RPN, r11 /* Store TLB entry */
+ mtspr SPRN_MD_CTR, r12
+ addi r12, r12, 0x100
+ mtspr SPRN_MD_EPN, r0
+ mtspr SPRN_MD_TWC, r10
+ mtspr SPRN_MD_RPN, r11
addis r9, r9, 0x80
addis r11, r11, 0x80
- cmpl cr0, r9, r12
- bdnzf gt, 1b
+ bdnz 1b
/* Since the cache is enabled according to the information we
* just loaded into the TLB, invalidate and enable the caches here.
diff --git a/arch/powerpc/mm/nohash/8xx.c b/arch/powerpc/mm/nohash/8xx.c
index d54d395c3378..43578a8a8cad 100644
--- a/arch/powerpc/mm/nohash/8xx.c
+++ b/arch/powerpc/mm/nohash/8xx.c
@@ -61,23 +61,6 @@ unsigned long p_block_mapped(phys_addr_t pa)
*/
void __init MMU_init_hw(void)
{
- /* PIN up to the 3 first 8Mb after IMMR in DTLB table */
- if (IS_ENABLED(CONFIG_PIN_TLB_DATA)) {
- unsigned long ctr = mfspr(SPRN_MD_CTR) & 0xfe000000;
- unsigned long flags = 0xf0 | MD_SPS16K | _PAGE_SH | _PAGE_DIRTY;
- int i = 28;
- unsigned long addr = 0;
- unsigned long mem = total_lowmem;
-
- for (; i < 32 && mem >= LARGE_PAGE_SIZE_8M; i++) {
- mtspr(SPRN_MD_CTR, ctr | (i << 8));
- mtspr(SPRN_MD_EPN, (unsigned long)__va(addr) | MD_EVALID);
- mtspr(SPRN_MD_TWC, MD_PS8MEG | MD_SVALID);
- mtspr(SPRN_MD_RPN, addr | flags | _PAGE_PRESENT);
- addr += LARGE_PAGE_SIZE_8M;
- mem -= LARGE_PAGE_SIZE_8M;
- }
- }
}
static bool immr_is_mapped __initdata;
@@ -225,7 +208,7 @@ void __init setup_initial_memory_limit(phys_addr_t first_memblock_base,
BUG_ON(first_memblock_base != 0);
/* 8xx can only access 32MB at the moment */
- memblock_set_current_limit(min_t(u64, first_memblock_size, 0x02000000));
+ memblock_set_current_limit(min_t(u64, first_memblock_size, SZ_32M));
}
/*
--
2.25.0
More information about the Linuxppc-dev
mailing list