[PATCH 1/1] serial/uuc_uart: Set shutdown timeout to CONFIG_HZ independent 2ms

[Alexander Stein]

On Monday 05 December 2016 10:04:27, Timur Tabi wrote:
> Alexander Stein wrote:
> > -		schedule_timeout(2);
> > +		schedule_timeout(msecs_to_jiffies(2));
> 
> NACK.
> 
> So I don't remember why I wrote this code, but I don't think I was
> expecting it to be 2ms.  Instead, I think I just wanted it to be some
> delay, but I believed that schedule_timeout(1) was too short or would be
> "optimized" out somehow.
> 
> Note that right below this, I do:
> 
> 	if (qe_port->wait_closing) {
> 		/* Wait a bit longer */
> 		set_current_state(TASK_UNINTERRUPTIBLE);
> 		schedule_timeout(qe_port->wait_closing);
> 	}
> 
> And wait_closing is a number of jiffies, so I knew that
> schedule_timeout() took jiffies as a parameter.
> 
> So I think I'm going to NACK this patch, since I believe I knew what I
> was doing when I wrote it five years ago.

Okay, I was just wondering why the timeout is dependant on the timer tick. 
That didn't seem obvious to me.
Rethinking about this, I would rather replace those lines with msleep instead.

Best regards,
Alexander