Problem with radeonfb on PowerPC 7448&MV64560

[Eduard Fuchs]

Am Freitag 20 März 2009 11:51:11 schrieb Detlev Zundel:
> Hi Eduard,
>
> > Am Mittwoch 18 März 2009 00:05:00 schrieb Benjamin Herrenschmidt:
> >> On Tue, 2009-03-17 at 16:30 +0100, Eduard Fuchs wrote:
> >> > Hi all,
> >> >
> >> > since several days I'm trying to run an ATI 9250 (PCI) graphic card
> >> > under Linux Kernel 2.6.27.19. Nevertheless without success. The kernel
> >> > shows the following message:
> >> >
> >> > videoboot: Booting PCI video card bus 0, function 0, device 7
> >> > biosEmu: undefined interrupt 15h called!
> >> > biosEmu/bios.int42: unknown function AH=0x0, AL=0x7, BL=0x0
> >>
> >> The above comes from some patches you added to the kernel ? You should
> >> probably do the softboot in the firmware instead...
> >
> > Yes. I'm using the videoboot-2.6x.patch (this patch contain also the
> > xf86emu from www.scitechsoft.com). With this pach the radeon card work
> > properly with 2.6.12 kernel version. On the 2.6.27 kernel the "videoboot"
> > fetch the bios from the video card and start them in the xf86emu.
> >
> > Can I initialize the video card in uboot too?
>
> Yes, indeed you can.  In a recent version of U-Boot, search for
> 'CONFIG_BIOSEMU' in include/configs/*.  We tested this on a sequoia
> board, so include/configs/sequoia.h should be a good start for this.

Thanks.

I tried to include BIOSEMU and RADEON_FB in my u-boot. Bios emulator seems to 
be properly loaded, but when u-boot attempt to read or write Radeon's 
registers, the board freezes.

What means exactly the value of "VIDEO_IO_OFFSET" in the config file? 

There is a u-boot's output when I init the VIDEO_IO_OFFSET with PCI's I/O base 
address:


INFO : PCI0_IO : base - 0xd8000000 size - 1M bytes
INFO : PCI0_MEM0: base - 0x80000000 size - 1024M bytes
INFO : PCI0_MEM1: base - 0xc0000000 size - 128M bytes
INFO : PCI0_MEM2: base - 0xc8000000 size - 128M bytes
INFO : PCI0_MEM3: base - 0xd0000000 size - 128M bytes
.....
PCI Scan: Found Bus 0, Device 7, Function 0
PCI Scan: Found Bus 0, Device 7, Function 1
PCI Scan: Found Bus 0, Device 9, Function 0
PCI Scan: Found Bus 0, Device 10, Function 0
Video: ATI Radeon video card (1002, 5960) found @(0:7:0)
videoboot: Booting PCI video card bus 0, function 0, device 7
E 0000 0 F00P0F000NI00PMS0EG 0F00

and after that follows board reset.

Best regards.

Eduard Fuchs