[PATCH 2/2] powerpc/83xx: Fix TSEC0 workability on MPC8313E-RDB boards

[Anton Vorontsov]

TSEC0 is connected to Vitesse 7385 5-port switch. The switch
isn't connected to any mdio bus, the link to the switch is fixed
to Full-duplex 1000 Mb/s (no pause).

This patch fixes following failure during bootup:

mdio at 24520:01 not found
eth0: Could not attach to PHY
IP-Config: Failed to open eth0

Signed-off-by: Anton Vorontsov <avorontsov at ru.mvista.com>
---
 arch/powerpc/boot/dts/mpc8313erdb.dts           |    9 ++-------
 arch/powerpc/configs/83xx/mpc8313_rdb_defconfig |    2 +-
 2 files changed, 3 insertions(+), 8 deletions(-)

diff --git a/arch/powerpc/boot/dts/mpc8313erdb.dts b/arch/powerpc/boot/dts/mpc8313erdb.dts
index 3f84cd0..3ebf7ec 100644
--- a/arch/powerpc/boot/dts/mpc8313erdb.dts
+++ b/arch/powerpc/boot/dts/mpc8313erdb.dts
@@ -191,7 +191,8 @@
 			interrupts = <37 0x8 36 0x8 35 0x8>;
 			interrupt-parent = <&ipic>;
 			tbi-handle = < &tbi0 >;
-			phy-handle = < &phy1 >;
+			/* Vitesse 7385 isn't on the MDIO bus */
+			fixed-link = <1 1 1000 0 0>;
 			fsl,magic-packet;
 
 			mdio at 24520 {
@@ -199,12 +200,6 @@
 				#size-cells = <0>;
 				compatible = "fsl,gianfar-mdio";
 				reg = <0x24520 0x20>;
-				phy1: ethernet-phy at 1 {
-					interrupt-parent = <&ipic>;
-					interrupts = <19 0x8>;
-					reg = <0x1>;
-					device_type = "ethernet-phy";
-				};
 				phy4: ethernet-phy at 4 {
 					interrupt-parent = <&ipic>;
 					interrupts = <20 0x8>;
diff --git a/arch/powerpc/configs/83xx/mpc8313_rdb_defconfig b/arch/powerpc/configs/83xx/mpc8313_rdb_defconfig
index 9e47ae9..409d017 100644
--- a/arch/powerpc/configs/83xx/mpc8313_rdb_defconfig
+++ b/arch/powerpc/configs/83xx/mpc8313_rdb_defconfig
@@ -651,7 +651,7 @@ CONFIG_CICADA_PHY=y
 # CONFIG_NATIONAL_PHY is not set
 # CONFIG_STE10XP is not set
 # CONFIG_LSI_ET1011C_PHY is not set
-# CONFIG_FIXED_PHY is not set
+CONFIG_FIXED_PHY=y
 # CONFIG_MDIO_BITBANG is not set
 CONFIG_NET_ETHERNET=y
 CONFIG_MII=y
-- 
1.5.6.5