Ethernet issues with lite5200 board from linux-2.6.31

[Grant Likely]

On Mon, Nov 30, 2009 at 2:50 AM, Yogesh Chaudhari <mr.yogesh at gmail.com> wrote:
> Hello,
>         I am running linux kernel with rt patch on embedded board
> based on lite5200 eval board. From linux-2.6.31 release, in which the
> mdio patch has gone inside,  the fec ethernet does not come up on this
> board. I get the following message at startup:
> mpc52xx MII bus: probed
> mdio_bus f0003000: error probing PHY at address 1
>
>
> After the bootup if I try to do a ifconfig I get the message:
> net eth2: of_phy_connect failed
>
>
> If I change the value of reg in dts file (lite5200.dts) to 0 then this
> ethernet comes up. However upto this kernel version, this was not
> required.
>
> Ethernet does not come up on board with original lite5200.dts file

Is your board based on the Lite5200 or the Lite5200B?  The phys are at
different addresses on those two revisions of the board.  There is a
different .dts file for each board.

> phy0: ethernet-phy at 1 {
>                                 reg = <1>;
>                         };
>
> Ethernet comes up on board with this change
> phy0: ethernet-phy at 1 {
>                                 reg = <0>;
>                         };

Some PHYs treat address 0 as the 'broadcast' address.  You need to
fill in this field (and modify the ethernet-phy@<address> node name)
to reflect the address that your phy is actually at.

g.