Floating inputs on unused GPIO pins
Geert Uytterhoeven
Geert.Uytterhoeven at sonycom.com
Mon Oct 13 21:03:29 EST 2008
On Mon, 13 Oct 2008, Laurent Pinchart wrote:
> our hardware engineer asked me to make sure all unused GPIO pins are configured as outputs to avoid floating inputs. He got theory on his side (floating inputs can lead to higher current consumption, metastability or even permanent damage), but I'd like to ask the list for practical feedback.
>
> I haven't been able to find any mention of floating input protection in the MPC8248 documents. Has anyone here experienced issues with floating inputs in real-life designs ? Do you setup your board with all unused GPIO pins configured as outputs ?
I always thought configurable GPIO pins default to _inputs_ after power-on, so
it's safe to tie them to VCC through a pull-up resistor?
For CMOS, you can tie them to VDD or GND without a resistor.
With kind regards,
Geert Uytterhoeven
Software Architect
Sony Techsoft Centre Europe
The Corporate Village · Da Vincilaan 7-D1 · B-1935 Zaventem · Belgium
Phone: +32 (0)2 700 8453
Fax: +32 (0)2 700 8622
E-mail: Geert.Uytterhoeven at sonycom.com
Internet: http://www.sony-europe.com/
A division of Sony Europe (Belgium) N.V.
VAT BE 0413.825.160 · RPR Brussels
Fortis · BIC GEBABEBB · IBAN BE41293037680010
More information about the Linuxppc-dev
mailing list