ARCH=ppc -> ARCH=powerpc : help needed for dts file

[David Gibson]

On Tue, Mar 11, 2008 at 12:46:02PM +0100, Philippe De Muyter wrote:
> Hi David,
> 
> On Tue, Mar 11, 2008 at 11:32:49AM +1100, David Gibson wrote:
> > On Sun, Mar 09, 2008 at 11:31:09PM +0100, Philippe De Muyter wrote:
> > > Hi Ben,
> > > 
> > > I now have a working linux on my mpc8540 based board, with support for
> > > the compactflash disk and the i2c rtc.
> > > 
> > > The network tough, does not work yet. altough the the integrated ethernet
> > > controller (FEC) seems to be recognized.  Could it be a problem with the phy ?
> > > I notice that I do not have an entry for gfar_interrupt in /proc/interrupts
> > > on my ethernet-missing linux, while I have one ont the working arch/ppc linux ?
> > > Do I need to give the phy type in the dts file, and how ?
> > > 
> > > I would also like to know if it is possible to still get in linux the mac
> > > address known by uboot when using a dts file, and how ?
> > 
> > This chiefly depends on whether you're using an old u-boot that
> > doesn't know about the device tree, or a new u-boot which itself
> > supplies a device tree to the kernel.
> > 
> > If the old u-boot, you'll need to write a bootwrapper for your
> > platform which reads the bd_t and pokes the right mac addresses into
> > the device tree.
> > 
> > If the new u-boot, u-boot itself should put the address into the
> > device tree.  If it's not, why it's not is a u-boot question rather
> > than a device tree question.
> 
> OK :(
> 
> Now back to the first an bigger problem :
> currently, I have an "old" U-boot and I have written myself a dts file.
> 
> Problem is : ethernet does not work, but that's not a mac-address problem,
> but something else that I do not understand yet.  The symptom is I get
> 
> 	ip route add default via 192.168.85.33 dev eth0
> 	RTNETLINK answers: Network is unreachable
> 
> I surmise this is because my eth0 does not become up, and I surmise
> again this is because there is no driver selected to drive the phy.
> 
> In my arch/ppc setup this was automagically handled by fixed at 100:1 IIRC  
> 
> Is there something I can put in my dts file to activate a driver for
> my phy ?

Probably, but how phy selection works is dependent on the ethernet
driver, so I can't help you.  You'll need someone familiar with the
driver in question (or read the code and figure it out).

-- 
David Gibson			| I'll have my music baroque, and my code
david AT gibson.dropbear.id.au	| minimalist, thank you.  NOT _the_ _other_
				| _way_ _around_!
http://www.ozlabs.org/~dgibson