"eth1: Could not attach to PHY" on MPC8349e-MITX
Andre Schwarz
andre.schwarz at matrix-vision.de
Fri Dec 5 04:41:54 EST 2008
Timur,
is it possible that the PHY adress doesn't match the one specified in
the dts ?
regards,
Andre
Timur Tabi schrieb:
> The Freescale MPC8349e-MITX reference board has two TSECs, the second
> of which (eth1) is attached to a Vitesse 7385 5-port switch.
>
> Using the latest U-Boot, Kernel, and device tree, I cannot bring up
> eth1. When I try, I get this message:
>
> [root at tintin root]# ifconfig eth1 up
> 0:01 not found
> eth1: Could not attach to PHY
> SIOCSIFFLAGS: No such device
>
> Unfortunately, I don't even know what this means.
>
> I believe my network configuration is correct. Here's what ifconfig
> says about eth1:
>
> eth1 Link encap:Ethernet HWaddr 00:E0:0C:00:8C:02
> inet addr:192.168.2.141 Bcast:192.168.255.255 Mask:255.255.0.0
> BROADCAST MULTICAST MTU:1500 Metric:1
> RX packets:0 errors:0 dropped:0 overruns:0 frame:0
> TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
> collisions:0 txqueuelen:1000
> RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
> Base address:0x4000
>
> eth1 does work in U-boot, so I know it can be made to work (and I know
> the 7385's firmware is uploaded), I just don't know what needs to be
> done in Linux.
>
MATRIX VISION GmbH, Talstraße 16, DE-71570 Oppenweiler - Registergericht: Amtsgericht Stuttgart, HRB 271090
Geschäftsführer: Gerhard Thullner, Werner Armingeon, Uwe Furtner
More information about the Linuxppc-dev
mailing list