[PATCH] [POWERPC] AMCC Kilauea (405EX): Disable EMAC loopback mode

[Benjamin Herrenschmidt]

On Sat, 2008-02-23 at 08:27 +1100, Benjamin Herrenschmidt wrote:
> On Fri, 2008-02-22 at 09:32 +0100, Stefan Roese wrote:
> > 405EX(r) has SDR0_MFR[E0CS/E1CS] set after reset. This selects
> > the internal loopback mode. Clear these bits so that both EMACs
> > don't use loopback mode as default.
> > 
> > Signed-off-by: Stefan Roese <sr at denx.de>
> > ---
> > I'm not sure if this should be done here in the board platform code,
> > or in the newemac driver or perhaps in some code common for 405EX.
> > 
> > Any thoughts on this welcome.
> 
> This should be done in EMAC since we also need to force internal
> loopback & clocking when probing the PHY or we might not probe
> it properly (and fail reset) if there is no link.

Is that patch still needed if I apply Valentine patches ? I'm fixing
them up so they don't break DCR MMIO anymore.

Cheers,
Ben.