Help:To Add NAND Node in Device Tree

[ashish]

Hi,   

      I am trying to add Nand Node in Device Tree, for My Board(Some what
similar to MPC8548_CDS). 

      In Board, Nand is attached to LBC UPM Controller. 

      Currently My NAND Driver working Fine without NAND Device Node in
Device Tree.

      But as Requirement, I have to add NAND Device Node in Device Tree.


      Can you give me some basic out lines to carry out this task? 

      I know that: 

          1. I have to make some changes in My NAND Driver to Read Device
Tree.

 

          2. Add NAND Node in Device Tree. But Again What property I need
for It. 

 

           Thanks in Advance.

 

 

With Best Regards

  Ashish Yadav  


-- 
eInfochips Business Disclaimer:
 
This message may contain confidential, proprietary or legally Privileged
information. In case you are not the original intended Recipient of the
message, you must not, directly or indirectly, use, Disclose,distribute,
print, or copy any part of this message and you are requested to delete
it and inform the sender. Any views expressed in this message are those
of the individual sender unless otherwise stated.Nothing contained in
this message shall be construed as an offer or acceptance of any offer
by eInfochips Limited and/or eInfochips Inc(“eInfochips”) unless sent
with that express intent and with due authority of eInfochips.EInfochips
has taken enough precautions to prevent the spread of viruses. However
the company accepts no liability for any damage caused by any virus
transmitted by this email.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ozlabs.org/pipermail/linuxppc-dev/attachments/20071211/62298ba6/attachment.htm>