[PATCH 16/19] [POWERPC] iSeries: hose->buid is always zero for iSeries

[Stephen Rothwell]

so remove a firmware feature test.

Signed-off-by: Stephen Rothwell <sfr at canb.auug.org.au>
---
 arch/powerpc/kernel/pci_64.c |    8 ++------
 1 files changed, 2 insertions(+), 6 deletions(-)

diff --git a/arch/powerpc/kernel/pci_64.c b/arch/powerpc/kernel/pci_64.c
index 69364f3..7e74aa2 100644
--- a/arch/powerpc/kernel/pci_64.c
+++ b/arch/powerpc/kernel/pci_64.c
@@ -581,12 +581,8 @@ int pcibios_enable_device(struct pci_dev *dev, int mask)
 /* Decide whether to display the domain number in /proc */
 int pci_proc_domain(struct pci_bus *bus)
 {
-	if (firmware_has_feature(FW_FEATURE_ISERIES))
-		return 0;
-	else {
-		struct pci_controller *hose = pci_bus_to_host(bus);
-		return hose->buid != 0;
-	}
+	struct pci_controller *hose = pci_bus_to_host(bus);
+	return hose->buid != 0;
 }
 
 void __devinit pci_process_bridge_OF_ranges(struct pci_controller *hose,
-- 
1.5.3.7

-- 
Cheers,
Stephen Rothwell                    sfr at canb.auug.org.au
http://www.canb.auug.org.au/~sfr/