PCI IDE Adapter for PPC/Linux

Matthew Locke mlocke at mvista.com
Tue Aug 14 03:20:33 EST 2001


The Promise Ultra-66 is known to work on several ppc platforms in
hhl-2.4.2.  Do you have the DMA options turned on in the kernel?

btw, if you are a MV customer contact support as this something we
support on the walnut and several other ppc platforms.


James F Dougherty wrote:

> (LOL) .... I have the Promise Ultra-66..... since it's
> not working, this is what prompted me to look for an
> alternative ..
>
> I have ported MontaVista HHL (Linux 2.4.2) to
> a custom processor board, and have been
> trying to run fdisk to setup a mountable root
> drive.
>
> Kernel is 2.4.2, with the Promise driver compiled in.
> I boot up, and it finds the card, and sometimes hdb
> is showing up in DMA mode ...
>
>
> pty: 256 Unix98 ptys configured
> block: queued sectors max/low 41386kB/13795kB, 128 slots per queue
> RAMDISK driver initialized: 16 RAM disks of 524288K size 1024 blocksize
> Uniform Multi-Platform E-IDE driver Revision: 6.31
> ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
> PDC20262: IDE controller on PCI bus 00 dev 70
> PDC20262: chipset revision 1
> PDC20262: not 100% native mode: will probe irqs later
> PDC20262: ROM enabled at 0x000d0000
> PDC20262: (U)DMA Burst Bit DISABLED Primary PCI Mode Secondary PCI Mode.
> PDC20262: FORCING BURST BIT 0x00 -> 0x01 ACTIVE
>     ide0: BM-DMA at 0xbfff00-0xbfff07, BIOS settings: hda:pio, hdb:pio
>     ide1: BM-DMA at 0xbfff08-0xbfff0f, BIOS settings: hdc:pio, hdd:pio
> udf: registering filesystem
> loop: loaded (max 8 devices)
> Serial driver version 5.02 (2000-08-09) with MANY_PORTS SHARE_IRQ SERIAL_PCI
> enabled
>
>
> mousse-(8):[11:29pm]: [/proc/ide>cat drivers
> ide-cdrom version 4.59
> ide-disk version 1.10
> mousse-(9):[11:29pm]: [/proc/ide>cat pdc202xx
>
>                                 PDC20262 Chipset.
> ------------------------------- General Status ---------------------------------
> Burst Mode                           : enabled
> Host Mode                            : Tri-Stated
> Bus Clocking                         : 100 External
> IO pad select                        : 10 mA
> Status Polling Period                : 15
> Interrupt Check Status Polling Delay : 15
> --------------- Primary Channel ---------------- Secondary Channel -------------
>                 disabled                         disabled
> 66 Clocking     enabled                          enabled
>            Mode MASTER                      Mode MASTER
>                 Error                            Error
> --------------- drive0 --------- drive1 -------- drive0 ---------- drive1 ------
> DMA enabled:    yes              yes             yes               yes
> DMA Mode:       NOTSET           NOTSET          NOTSET            NOTSET
> PIO Mode:       NOTSET            NOTSET           NOTSET            NOTSET
> mousse-(10):[11:29pm]: [/proc/ide>
>
>
> Now, when I run fdisk .... it either cannot find the device (when
> compiled kernel with INCLUDE_DEVFS
>
> mousse-(17):[11:31pm]: [/>devfsd /dev
> Started device management daemon for /dev
> mousse-(18):[11:31pm]: [/>fdisk /dev/hda
> modprobe: Can't locate module /dev/hda
> modprobe: Can't locate module /dev/hda
>
> Unable to open /dev/hda
> mousse-(19):[11:31pm]: [/>fdisk /dev/hdb
> modprobe: Can't locate module /dev/hdb
> modprobe: Can't locate module /dev/hdb
>
> Unable to open /dev/hdb
> mousse-(20):[11:31pm]: [/>
>
> Or, when I run with a standard dev filesystem and the device
> files created with scripts/MAKEDEV.ide it gives me an error,
> cant find module block-3 blah blah blah...
>
>
> Any ideas?
>
>
>
>
>
>
>
>>
>> A good shot is always the Promise cards.  I know at least the 66 used
>> to work, and I'm reasonably sure the 100 does.  You'll need 2.4 for it
>> though, and no booting off it.
>>
>> On Sun, Aug 12, 2001 at 11:49:14PM -0700, James F Dougherty wrote:
>>
>>> I guess my question is which drivers run in native mode
>>> (e.g. do not require an x86 ROM BIOS).
>>>
>>>
>>>> Anyone have any suggestions for a PCI IDE card to
>>>> use for PPC/Linux? Something one could buy down
>>>> at a Frye's would be great.
>>>>
>>>>
>>>> Many thanks in advance.
>>>> 				-James
>>>>
>>>>
>>>>
>>>
>>>
>>>
>> --
>> Daniel Jacobowitz                           Carnegie Mellon University
>> MontaVista Software                         Debian GNU/Linux Developer
>>
>>
>
>


** Sent via the linuxppc-dev mail list. See http://lists.linuxppc.org/





More information about the Linuxppc-dev mailing list