G3 Upgrade Questions....

[Neil Jolly]

ian geiser wrote:

> Hello,
>     I just installed a G3 upgrade card into my powercenter132
>     It is a 400Mhz with 1Meg at 200Mhz....
>     It registers under MacOS perfectly but i get the following under
>     proc/cpuinfo:
>     processor       : 0
>     cpu             : 750
>     temperature     : 0 C            <--Is this correct?!
>     clock           : 195MHz        <-- Is this correct?!
>     revision        : 130.1
>     bogomips        : 399.77
>     zero pages      : total 0 (0Kb) current: 0 (0Kb) hits: 0/1084 (0%)
>     machine         : Power Macintosh
>     motherboard     : AAPL,7300 MacRISC
>     memory          : 112MB
>
>     it only registers 195 Mhz and 0C for the temp... is the correct?
>     i am running Kernel 2.2.10

Here's a peek at my cpu info. A 233 G3 clocked to 292 with 83mhz bus, and
runs around 106 degrees F. Obviously the temp is not accurate, but clock
seems to be pretty close.

processor       : 0
cpu             : 750
temperature     : 0 C
clock           : 290MHz
revision        : 2.2
bogomips        : 581.63
zero pages      : total 0 (0Kb) current: 0 (0Kb) hits: 0/558 (0%)
machine         : Power Macintosh
motherboard     : AAPL,Gossamer MacRISC
L2 cache        : 512K unified pipelined-syncro-burst
memory          : 96MB


Neil


[[ This message was sent via the linuxppc-dev mailing list.  Replies are ]]
[[ not  forced  back  to the list, so be sure to Cc linuxppc-dev if your ]]
[[ reply is of general interest. Please check http://lists.linuxppc.org/ ]]
[[ and http://www.linuxppc.org/ for useful information before posting.   ]]