[PATCH 1/1] pinctrl: aspeed-g6: Add NCSI pin group config

Andrew Jeffery andrew at codeconstruct.com.au
Thu Jun 20 09:45:48 AEST 2024


On Wed, 2024-06-19 at 19:24 +0800, Potin Lai wrote:
> On Mon, Jun 17, 2024 at 3:33 PM Andrew Jeffery
> <andrew at codeconstruct.com.au> wrote:
> > 
> > On Thu, 2024-06-13 at 16:07 +0800, Potin Lai wrote:
> > > In the NCSI pin table, the reference clock output pin (RMIIXRCLKO) is not
> > > needed on the management controller side.
> > > 
> > > To optimize pin usage, add new NCSI pin groupis that excludes RMIIXRCLKO,
> > > reducing the number of required pins.
> > 
> > Hmm, I'm not convinced this is specific to NCSI (and it's an
> > unfortunate mistake on my part), but we do need to call the groups
> > something different than RMII[34]. Did you have any other suggestions?
> > 
> I don't have better name for now.
> In ast2600 data sheet, it also mentioned "RMII" & "NCSI" together most
> of the time, is it ok to use "NCSI" as a new group name?

Perhaps we go with "NCSI", because the other thoughts I had are all
much less succinct.

Can you please add a note to the description in the binding that
discusses the difference between the RMII and NCSI groups?

Andrew



More information about the Linux-aspeed mailing list