[RFC PATCH v5 0/1] drivers: mfd: Versatile Express SPC support

[Samuel Ortiz]

Hi Lorenzo,

On Tue, Jul 16, 2013 at 05:05:42PM +0100, Lorenzo Pieralisi wrote:
> Hello,
> 
> version v5 of VExpress SPC driver, please read on the changelog for major
> changes and explanations.
> 
> The probing scheme is unchanged, since after trying the early platform
> devices approach it appeared that the end result was no better than the
> current one. The only clean solution relies either on changing how
> secondaries are brought up in the kernel (later than now) or enable
> early platform device registration through DT. Please check this
> thread for the related discussion:
> 
> https://lists.ozlabs.org/pipermail/devicetree-discuss/2013-June/036542.html
> 
> The interface was adapted to regmap and again reverted to old driver for
> the following reasons:
> 
> - Power down registers locking is hairy and requires arch spinlocks in
>   the MCPM back end to work properly, normal spinlocks cannot be used
> - Regmap adds unnecessary code to manage SPC since it is just a bunch of
>   registers used to control power management flags, the overhead is just
>   not worth it (talking about power down registers, not the vexpress config
>   interface)
> - The locking scheme behind regmap requires all registers in the map
>   to be protected with the same lock, which is not exactly what we want
>   here
> - Given the reasons above, adding a regmap interface buys us nothing from
>   a driver readability and maintainability perspective (again just talking
>   about the power interface, a few registers) because for the SPC it would
>   simply not be used
> 
> /drivers/mfd is probably not the right place for this code as it stands (but
> probably will be when the entire driver, with DVFS and config interface, is
> complete).
Could you please elaborate on how will the SPC driver extend into an MFD
driver?

Cheers,
Samuel.

-- 
Intel Open Source Technology Centre
http://oss.intel.com/