[PATCH v8] reset: Add driver for gpio-controlled reset pins

[Stephen Warren]

On 07/16/2013 12:51 AM, Shawn Guo wrote:
> On Tue, Jul 16, 2013 at 09:50:42AM +0800, Shawn Guo wrote:
>> Hi Philipp,
>>
>> On Thu, May 30, 2013 at 11:09:00AM +0200, Philipp Zabel wrote:
>>> This driver implements a reset controller device that toggle a gpio
>>> connected to a reset pin of a peripheral IC. The delay between assertion
>>> and de-assertion of the reset signal can be configured via device tree.
>>>
>>> Signed-off-by: Philipp Zabel <p.zabel at pengutronix.de>
>>> Reviewed-by: Stephen Warren <swarren at nvidia.com>
>>
>> I see this patch is very useful, as GPIOs are widely used to reset
>> components/devices on board.  But I do not find the patch in v3.11-rc1.
>> What's your plan about it?
>>
>> Also, I'm wondering if we should register the driver a little bit
>> early.  Please see the following patch.  If it makes sense to you,
>> I can send the patch to you, or you can just quash it into yours.
> 
> And here is another change request.

> diff --git a/drivers/reset/gpio-reset.c b/drivers/reset/gpio-reset.c

> -	gpio_set_value(drvdata->gpio, value);
> +	if (gpio_cansleep(drvdata->gpio))
> +		gpio_set_value_cansleep(drvdata->gpio, value);
> +	else
> +		gpio_set_value(drvdata->gpio, value);

That's not right. Calling gpio_set_value() v.s.
gpio_set_value_cansleep() should be based on the properties of the
calling context, not the GPIO being controlled. In other words, if it's
permissible to call gpio_set_value_cansleep() at this point in the code,
simply always call that, and remove the conditional logic.