[PATCH v3 1/4] drivers: usb: phy: add a new driver for usb part of control module

[kishon]

On Friday 25 January 2013 01:18 PM, Felipe Balbi wrote:
> On Thu, Jan 24, 2013 at 09:32:46PM -0800, Stephen Warren wrote:
>> On 01/24/2013 06:19 PM, Kishon Vijay Abraham I wrote:
>>> Added a new driver for the usb part of control module. This has an API
>>> to power on the USB2 phy and an API to write to the mailbox depending on
>>> whether MUSB has to act in host mode or in device mode.
>>>
>>> Writing to control module registers for doing the above task which was
>>> previously done in omap glue and in omap-usb2 phy will be removed.
>>
>>> diff --git a/Documentation/devicetree/bindings/usb/usb-phy.txt b/Documentation/devicetree/bindings/usb/usb-phy.txt
>>
>> This file seems to be specific to the TI USB PHYs, not all USB PHYs;
>> shouldn't it be renamed ti-usb-phy.txt, or even better renamed to match
>> the compatible value it documents, giving ti,omap-usb2.txt?
>
> could be, but that can be done as a separate patch. It's not part of
> $SUBJECT.
>
>>>   add the address of control module dev conf register until a driver for
>>>   control module is added
>>>
>>> +Optional properties:
>>> + - ctrl_module : phandle of the control module used by PHY driver to power on
>>> +   the PHY.
>>
>> DT property names generally use - not _ as the word separator.
>
> fair enough, Kishon, can you fix this up ?

Sure. Will post a patch..

Thanks
Kishon