[PATCH 1/3] gpio: Add simple poweroff-gpio driver

Jamie Lentin jm at lentin.co.uk
Fri Nov 16 05:11:11 EST 2012


On Thu, 15 Nov 2012, Grant Likely wrote:

> On Sun, 11 Nov 2012 17:21:29 +0100, Andrew Lunn <andrew at lunn.ch> wrote:
>> From: Jamie Lentin <jm at lentin.co.uk>
>>
>> Given appropriate devicetree bindings, this driver registers a
>> pm_power_off function to set a GPIO line high/low to power down
>> your board.
>>
>> Signed-off-by: Jamie Lentin <jm at lentin.co.uk>
>> Signed-off-by: Andrew Lunn <andrew at lunn.ch>
>> ---
>>  .../devicetree/bindings/gpio/gpio-poweroff.txt     |   22 ++++
>>  drivers/gpio/Kconfig                               |   10 ++
>>  drivers/gpio/Makefile                              |    2 +
>>  drivers/gpio/gpio-poweroff.c                       |  129 ++++++++++++++++++++
>
> This isn't a gpio controller driver. Don't put it into drivers/gpio

There's a v2 which puts it in drivers/power/reset/gpio-poweroff.c

>
> g.
>
>

-- 
Jamie Lentin


More information about the devicetree-discuss mailing list