[PATCH 1/3] gpio: Add simple poweroff-gpio driver

Grant Likely grant.likely at secretlab.ca
Fri Nov 16 05:21:20 EST 2012


On Thu, Nov 15, 2012 at 6:11 PM, Jamie Lentin <jm at lentin.co.uk> wrote:
> On Thu, 15 Nov 2012, Grant Likely wrote:
>
>> On Sun, 11 Nov 2012 17:21:29 +0100, Andrew Lunn <andrew at lunn.ch> wrote:
>>>
>>> From: Jamie Lentin <jm at lentin.co.uk>
>>>
>>> Given appropriate devicetree bindings, this driver registers a
>>> pm_power_off function to set a GPIO line high/low to power down
>>> your board.
>>>
>>> Signed-off-by: Jamie Lentin <jm at lentin.co.uk>
>>> Signed-off-by: Andrew Lunn <andrew at lunn.ch>
>>> ---
>>>  .../devicetree/bindings/gpio/gpio-poweroff.txt     |   22 ++++
>>>  drivers/gpio/Kconfig                               |   10 ++
>>>  drivers/gpio/Makefile                              |    2 +
>>>  drivers/gpio/gpio-poweroff.c                       |  129
>>> ++++++++++++++++++++
>>
>>
>> This isn't a gpio controller driver. Don't put it into drivers/gpio
>
>
> There's a v2 which puts it in drivers/power/reset/gpio-poweroff.c

Okay, thanks.

g.


More information about the devicetree-discuss mailing list