[PATCH V3 1/2] of: Add generic device tree DMA helpers

[Stephen Warren]

On 05/21/2012 12:18 PM, Arnd Bergmann wrote:
> On Monday 21 May 2012, Stephen Warren wrote:
>>>
>>> The point with the direction was that it covers most cases and makes
>>> them rather simple, while for the rare case where you need more than
>>> two channels, you just use the otherwise optional named interface
>>> rather than the numbered one. My feeling is that this also makes a
>>> lot of sense at the driver API level: most dirvers just ask for the
>>> read and write channels using a very simple interface, and those drivers
>>> that have more than two will want to name them anyway.
>>
>> How are you thinking of representing the direction in DT - as part of
>> the DMA request specifier, so in a DMAC-specific way?
>>
>> If so, that seems a little odd; you have to request a DMA channel for
>> "TX", but then end up having the common code check all the entries in
>> the dmas property since it can't know which are TX, and then have the
>> wrong ones almost accidentally fail, since the DMAC will then determine
>> that it can't support TX on the RX DMA request IDs.
> 
> I think the direction must be encoded in a way that does not depend on
> the binding for the specific controller. There are two ways I can see
> how we might do it:
> 
> 1. have separate property names for tx and rx channels, and probably
>    one for combined rx/tx channels

> 2. define the second cell in each channel specifier to be the direction
>    in a predefined format, followed by the other (controller specific)
>    attributes, if any.

In this option, lets say bit 0 is 0==TX, 1==RX (or perhaps 2 bits if
combined TX/RX is needed)

Then, we could reserve say bits 7:1 as client DMA request ID.

And then have bits 31:8 as DMAC specific data.

Wouldn't that allow us to have our cake and eat it?