Where to power on the wifi device before loading the driver.

[Stephen Warren]

On 06/14/2012 06:12 AM, Mark Brown wrote:
> On Thu, Jun 14, 2012 at 08:31:20AM +0200, Thierry Reding wrote:
>> On Wed, Jun 13, 2012 at 03:17:06PM -0600, Stephen Warren wrote:
> 
>>> The core of the issue is that:
> 
>>> * Tegra30 support is via device tree. * We have an SDIO bus,
>>> and the WiFi device attached to that bus is enumerable. * Since
>>> the WiFi device is enumerable, no node exists in the DT to 
>>> represent it. * However, the driver for the WiFi device needs
>>> certain information, such as the reset GPIO ID and perhaps
>>> power GPIO.
> 
>> PCI devices are also enumerable and yet they can be matched up
>> with nodes in the device tree. Perhaps something similar could be
>> added for the SDIO bus?
> 
> This seems to make the most sense - pushing this through the
> regulator API is just a bodge.

Yes, that seems reasonable.

Presumably the power GPIO should be a fixed regulator though, since it
is a power control not just a plain old GPIO? That said, the current
driver apparently deals with this as a GPIO already.

The reset GPIO can separately/directly controlled by the WiFi driver
though.