[RFC] [PATCH] ARM: tegra: emc: device tree bindings

Rob Herring robherring2 at gmail.com
Wed Oct 19 13:37:53 EST 2011


On 10/18/2011 04:01 PM, Stephen Warren wrote:
> Olof Johansson wrote at Tuesday, October 18, 2011 2:54 PM:
>> On Tue, Oct 18, 2011 at 11:54 AM, Stephen Warren <swarren at nvidia.com> wrote:
>>> Olof Johansson wrote at Tuesday, October 18, 2011 12:43 PM:
> ...
>>>> Compatible is still needed, in my opinion -- otherwise there will be
>>>> no way to tell if the node is there to describe emc timings or if it's
>>>> some new node used to describe something else (such as SDRAM chips as
>>>> mentioned above).
>>>
>>> Can't you go by node name; enumerate all nodes with a particular name.
>>> Or define another intermediate node that will always contain tables and
>>> nothing else, then just enumerate all child nodes of that node:
>>>
>>> emc at xxxxx {
>>>    emc-tables {
>>>        table-333 at 0 {};
>>>        table-666 at 0 {};
>>>    };
>>> };
>>>
>>> The Tegra pinmux bindings I proposed certainly used this technique; a
>>> main node with a well-known name, followed by enumeration of all child
>>> nodes of that, and nobody /said/ anything about that being a bad idea.
>>
>> I'm not really picky on this, but I think I would rather use a
>> compatible field than rely on naming.
>>
>> That being said, doing a two-level approach will probably make it
>> easier than the flat structure I initially had. So:
>>
>> emc at xxx {
>>     nvidia,use-ram-code;
>>     emc-table-ram-code-0 {
>>         nvidia,ram-code = < 0 >;
>>         table-166 { compatible = "tegra20-emc-table"; ... };
>>         table-333 { ... };
>>     };
>>
>>     emc-table-ram-code-1 {
>>         nvidia,ram-code = < 1 >;
>>         ...
>>     };
>> };
>>
>> ... and for none-ram-code, just leave out the emc-table-ramcode-x level.
>>
>> So, for nvidia,use-ram-code case, it'll be one intermediate step of
>> finding the right subnode, the rest of the table setup code will be
>> common. None of it will be bound to actual node names though -- first
>> step is iterating child nodes looking for nvidia,ram-code properties
>> to match, and second step iterates by matching compatible fields.
> 
> I only suggested the well-known-named sub-nodes in order to eliminate
> the need for a compatible property.
> 
> My inclination is that if we use compatible to distinguish the tables
> from anything else, there's little point having the extra level of nodes;
> we may as well lay it out as in your original patch, just with an explicit
> nvidia,ram-code property in each table (or omitted/ignored when not using
> it) instead of reg?

Node names should be generic like serial or ethernet. Compatible is used
to specify the specific model.

Rob


More information about the devicetree-discuss mailing list