[PATCH 0/6] ARM: at91: irqdomain and device tree for AIC and GPIO

Nicolas Ferre nicolas.ferre at atmel.com
Sat Dec 17 03:29:29 EST 2011


On 12/16/2011 02:53 AM, Rob Herring :
> Nicolas,
> 
> On 12/15/2011 01:16 PM, Nicolas Ferre wrote:
>> Hi,
>>
>> This series adds irqdomain and device tree support for both the
>> interrupt and GPIO controllers of AT91 SoC.
>>
>> The AIC part has already been sent some time ago but has been
>> reworked to address Rob's comments. This reworked patch is marked
>> with a "v4" tag.
>>
>> The series can go on top of Jamie's patch
>> "irqdomain: export irq_domain_simple_ops for !CONFIG_OF"
>> and has been tested on top of 'v3.2-rc5' + 'arm-soc/at91/ioremap'
>> and 'arm-soc/at91/gpio'
>>
>> Jean-Christophe PLAGNIOL-VILLARD (1):
>>       ARM: at91/gpio: add DT support
>>
>> Nicolas Ferre (5):
>>       ARM: at91/aic: add irq domain and device tree support
>>       ARM: at91/gpio: add irqdomain to gpio interrupts
>>       ARM: at91/gpio: add .to_irq gpio_chip handler and rework irq_to_gpio
>>       ARM: at91/gpio: remove the static specification of gpio_chip.base
>>       ARM: at91/board-dt: remove AIC irq domain from board file
>>
>>  .../devicetree/bindings/arm/atmel-aic.txt          |   38 ++++
>>  .../devicetree/bindings/gpio/gpio_at91.txt         |   20 ++
>>  arch/arm/Kconfig                                   |    1 +
>>  arch/arm/boot/dts/at91sam9g20.dtsi                 |   44 ++++-
>>  arch/arm/boot/dts/at91sam9g45.dtsi                 |   59 +++++-
>>  arch/arm/mach-at91/board-dt.c                      |   15 +--
>>  arch/arm/mach-at91/gpio.c                          |  197 ++++++++++++++++----
>>  arch/arm/mach-at91/include/mach/gpio.h             |   12 --
>>  arch/arm/mach-at91/include/mach/irqs.h             |    3 +-
>>  arch/arm/mach-at91/irq.c                           |   91 +++++++--
>>  10 files changed, 383 insertions(+), 97 deletions(-)
>>  create mode 100644 Documentation/devicetree/bindings/arm/atmel-aic.txt
>>  create mode 100644 Documentation/devicetree/bindings/gpio/gpio_at91.txt
> 
> What about using generic irq chip as I previously mentioned? It looks to
> me like both the AIC and gpio controller could use it. I've added irq
> domain support to generic irq chip, so it should simplify your changes.
> The latest branch is here:
> 
> git://sources.calxeda.com/kernel/linux.git pl061-domain-v2

Rob,

Yes, that definitively makes sense but I fear that this rework will
delay again the introduction of a couple of products and the work we
have to do to enable DT for other drivers.
The AIC and GPIO will definitively need a rework but I cannot start this
now and as I have a nearly working solution, I would prefer to start
this task later...

Best regards,
-- 
Nicolas Ferre


More information about the devicetree-discuss mailing list