[Skiboot] [RFC PATCH 2/2] EXAMPLE: Print full DT path when adding a node

[Oliver]

On Thu, Mar 8, 2018 at 12:09 PM, Stewart Smith
<stewart at linux.vnet.ibm.com> wrote:
> Oliver O'Halloran <oohall at gmail.com> writes:
>> An example of how to use the custom printf specifiers. In this case it
>> will print out the full node path when adding a node to
>> the device-tree, like so:
>>
>> [    0.001493894,3] Added /ibm,opal to tree
>> [    0.001504982,3] Added /ibm,opal/event to tree
>> [    0.001512892,3] Added /ibm,opal/firmware to tree
>> [    0.001521920,3] Added /ibm,opal/firmware/exports to tree
>> [    0.001535936,3] Added /ibm,opal/power-mgt to tree
>
> Immediate uses I could see would be replacing the PHB(DBG|INFO|ERR)
> macros that do the PHB#%04x[%d:%d]: printing, the lock printing code,
> the mbox-flash window printing code, and some of the FSP message logging
> stuff.
>
> We can probably end up unit testing this code too without *tooo* much
> swearing.

Due to the stupid linker trick I was doing unit testing this is a bit
hard. I was
going to rework it at some point but haven't gotten around to it yet.

things_to_do++

>
> Is cleaning it up/converting somewhere on the radar at all?
>
> --
> Stewart Smith
> OPAL Architect, IBM.
>