[Skiboot] [PATCH v2 8/8] capp/phb4: Prevent HMI from getting triggered when disabling CAPP

[Vaibhav Jain]

While disabling CAPP an HMI gets triggered as soon as ETU is put in
reset mode. This is caused as before we can disabled CAPP, it detects
PHB link going down and triggers an HMI requesting Opal to perform
CAPP recovery. This has an un-intended side effect of spamming the
Opal logs with malfunction alert messages and may also confuse the
user.

To prevent this we mask the CAPP FIR error 'PHB Link Down' Bit(31)
when we are disabling CAPP just before we put ETU in reset in
phb4_creset(). Also now since bringing down the PHB link now wont
trigger an HMI and CAPP recovery, hence we manually set the
PHB4_CAPP_RECOVERY flag on the phb to force recovery during creset.

Signed-off-by: Vaibhav Jain <vaibhav at linux.ibm.com>
---
Change-log:

v2	Use the member 'struct capp->capp_xscom_offset' to find the
	xscom register offset instead of 'PHB4_CAPP_REG_OFFSET'.
---
 hw/phb4.c | 11 +++++++++++
 1 file changed, 11 insertions(+)

diff --git a/hw/phb4.c b/hw/phb4.c
index 36353b74..ca3c1065 100644
--- a/hw/phb4.c
+++ b/hw/phb4.c
@@ -3295,6 +3295,7 @@ static void disable_capi_mode(struct phb4 *p)
 static int64_t phb4_creset(struct pci_slot *slot)
 {
 	struct phb4 *p = phb_to_phb4(slot->phb);
+	struct capp *capp = slot->phb->capp;
 	uint64_t pbcq_status, reg;
 
 	/* Don't even try fixing a broken PHB */
@@ -3310,6 +3311,16 @@ static int64_t phb4_creset(struct pci_slot *slot)
 		/* Clear error inject register, preventing recursive errors */
 		xscom_write(p->chip_id, p->pe_xscom + 0x2, 0x0);
 
+		/* Prevent HMI when PHB gets fenced as we are disabling CAPP */
+		if (p->flags & PHB4_CAPP_DISABLE &&
+		    capp && capp->phb == slot->phb) {
+			/* Since no HMI, So set the recovery flag manually. */
+			p->flags |= PHB4_CAPP_RECOVERY;
+			xscom_write_mask(p->chip_id, capp->capp_xscom_offset +
+					 CAPP_FIR_MASK,
+					 PPC_BIT(31), PPC_BIT(31));
+		}
+
 		/* Force fence on the PHB to work around a non-existent PE */
 		if (!phb4_fenced(p))
 			xscom_write(p->chip_id, p->pe_stk_xscom + 0x2,
-- 
2.19.2