[PATCH v6 4/4] i2c: npcm: Enable slave in eob interrupt

[Tyrone Ting]

Hi Andy:

Thank you for your feedback.

Andy Shevchenko <andriy.shevchenko at linux.intel.com> 於 2024年10月11日 週五 下午7:02寫道：
>
> On Fri, Oct 11, 2024 at 01:52:31PM +0800, Tyrone Ting wrote:
> > From: Charles Boyer <Charles.Boyer at fii-usa.com>
> >
> > Nuvoton slave enable was in user space API call master_xfer, so it is
> > subject to delays from the OS scheduler. If the BMC is not enabled for
> > slave mode in time for master to send response, then it will NAK the
> > address match. Then the PLDM request timeout occurs.
> >
> > If the slave enable is moved to the EOB interrupt service routine, then
> > the BMC can be ready in slave mode by the time it needs to receive a
> > response.
>
> ...
>
> > +#if IS_ENABLED(CONFIG_I2C_SLAVE)
> > +             /* reenable slave if it was enabled */
> > +             if (bus->slave)
> > +                     iowrite8((bus->slave->addr & 0x7F) | NPCM_I2CADDR_SAEN,
>
> GENMASK()?
> But why do we need it? Do we expect this to be 10-bit address or...?
>

0x7f is going to be removed in the next patch set.

> > +                              bus->reg + NPCM_I2CADDR1);
> > +#endif
>
> --
> With Best Regards,
> Andy Shevchenko
>
>

Thank you.

Regards,
Tyrone